How To Program ATA PTX-4 Garage Remotes

Views 1 Like Comments Comment
Like if this Guide is helpful

OPERATION


To open a door or gate using the remote simply press one of the programmed channel buttons for two seconds.
Each press of the button will cycle through an open, stop or close action.
Link to an eBay page Remove
Add up to 3 more photos
Link to an eBay page

STORING TRANSMITTER CODE


1. Press and hold the blue Door Code button on the opener or SW1 or SW2 on the receiver board.
2. Press the transmitter button you would like to use to control the door for two seconds.
3. Release and pause for two seconds. Press the same button again for two seconds.
4. Release the Door Code or SW button.
5. Press the transmitter button to test operation.
You must own a original working remote with the pin hole to program aftermarket remotes using the remote location method
Link to an eBay page Remove
Add up to 3 more photos
Link to an eBay page
You must own a original working remote with the pin hole to program aftermarket remotes using the remote location method

STORING TRANSMITTER FROM A REMOTE LOCATION

Using this method you do not need to have direct access to the control panel or receiver.
However, you do need an original  working remote that is already coded into the opener.
IMPORTANT NOTE: The door/gate or courtesy light will be activated when the step below is performed.
The moving door/gate or light switching on is to confirm that the correct button was pressed and the transmitter is in range of the opener.

1. Take any pre-coded original ATA PTX-4 transmitter.
Press the button for the function you require until the door/gate is activated and release.
2 Then using a small needle press through the Coding Hole and hold firmly for two seconds.
3. Within 10 seconds take the additional aftermarket transmitter you wish to code.
4. Press the aftermarket transmitter button you would like to use to control the door for two seconds.
5. Pause for two seconds then press the same button again for two seconds.
This button should now be coded.
5. Wait for 10 seconds, then press the just coded aftermarket transmitter button to confirm that it operates the door/gate etc.

DELETING ALL STORED TRANSMITTER CODES


1. Turn the power off to the opener.
2 Press and hold Door Code or SW1 button.
3. Turn the power on again, while holding the button.
The Coding LED will illuminate to indicate that the receivers memory has been deleted.
4. Release the button.
All the stored codes including the courtesy light codes should now be deleted.
Confirm this by pressing the transmitters previously used to operate the device.
There should be no response.

Programming buttons for the above board
Link to an eBay page Remove
Add up to 3 more photos
Link to an eBay page
Programming buttons for the above board
Programming buttons for the above board
Link to an eBay page Remove
Add up to 3 more photos
Link to an eBay page
Programming buttons for the above board
Have something to share, create your own Guide... Write a Guide
Explore more Guides