So the heat’s really affecting your garden and you’re getting sick of getting up early to hand water your plants. You’ve decided to take up the challenge of installing a drip system yourself and need to know what’s involved. Don’t worry it’s not too hard, but there’s some things you need to keep in mind to make sure your garden gets watered properly. (For the purpose of this guide we will start from the outlet of the Solenoid Valves.)
Draw Up A Plan of Your Garden
The first step is to create a scale drawing of your garden, to help you calculate accurate line lengths it is vitally important that the plan is to scale.
Choose Your Type of Drip Tube
Toro Drip-Eze has drippers every 30cms and each drips at 2 litres per hour. Some varieties aren't pressure compensating, which means more water can flow out of low points than high points in the garden, so they're recommended for flat garden beds. (Only combine different drip tubes with the same flow rate to ensure even watering)
Netafim TechlineAS also has drippers every 30cms but drips at 3 lph so you can get more water on your garden in a shorter time period. TechlineAS is great for undulating gardens because it is pressure compensating and can be run for a max 72m. Unlike Toro Drip-Eze this tube is anti-syphon so there is no need for vacuum breakers.
Planning and Laying Drip Tube
For your garden to be watered effectively it is important that your tube is planned and laid correctly. In a garden bed with regular soil that’s not too sandy or full of clay, we suggest running a line of tube around the perimeter and then connecting lines 40cms apart through the middle. For sandy soil lay the lines closer together (30cms) and for heavier soils lay further apart (50cms). Also keep in mind that your Drip Tube will try and lift from the ground when you are laying it out so you will need Galvanised Steel Pins to secure it to the ground.
Calculating Your Fittings
The accuracy of your plan will determine how well you can do this step. The important thing with calculating your fittings will be to keep in mind the size of pipe you are using. We suggest running either 19mm or 13mm Poly Pipe from your Solenoid Valve to your 13mm Drip Tube.
So when connecting 19mm Poly to Drip Tube you will need to decide whether a 10mm x 13mm Poly Fitting punched into the poly with a 10mm Punch Tool would be better than cutting a 19mm x 13mm Fitting. If connecting 13mm Poly Tube to Drip Tube you will just need 13mm Poly Fittings.
When calculating the elbows, tees and joiners you’ll need to refer to you plan, wherever you see a 90° bend add an elbow, where you see a junction, add a tee or a cross.
Flush, Program & Operate!
Before you turn on your system you need to flush your lines, this can be done with a Netafim Flush Valve or 13mm Shut Off Tap. Then program the Time Clock , because of the method of water distribution, Drip Tube needs to be run for longer, depending on the time of year this could be 45 mins to 2 hours. Now you can watch your garden turn green again!