Please note that we ship the item to your eBay
THIS IS NOT A GENUINE PRODUCT
2 * COMMODORE AFTER MARKET HEAD REPLACEMENT SHELL
NEW SOFT BUTTONS !!!
Good quality 3 Button Remote Key Shell for
Suits for VS VT VX VY VZ WH WK WL.
YOU DO NOT NEED GLUE TO GET THE SEALED KEY
This remote shell fits Holden 3 button remotes
and also 1 or 2 button remotes keys.
Note: This is just a shell, there is NO
You will be required to open the old remote to
remove the internal module and insert it into this item.
2 x Shell (case) front (with soft buttons) and back
(use the 3 button shell on 1 or 2 button remote)
2 x new uncut key blank
4 x new screws
These shells are very easy to fit, it takes just five minutes to replace it.
Simply remove the key blade from your old shell,
screwing two screws.
Place a large flat blade screwdriver, into the hole
where the key blade was, gently pull the shell pieces
Remove the module with the gasket to the new shell.
Put the module and gasket corectly to the half
with out buttons.
Close the two halves of new shell together, Near the key ring end of the front (with the buttons) shell
there is a clip, this clip will easily fit on to the other shell piece. You
have to put it together and press hard (half with buttons) on the back to
connect correctly two shell parts. After this the two parts of the shell should
If your using your old blade, use your old screws
(Sometimes the original screws are too short or in bed position, to use the new
one, you have to drill or scrape (by little screwdriver) old holes a little bit
to diameter 3mm . If you have the new blade cut, use
the new screws. Place your blade in the slot and tighten the screws
All done !!!
Enjoy your new key !!!
We offer best quality shell on market