3 x Magic Photo Transfer Decal Paper - LASER Paper

3 X A4 size sheets of MAGIC PHOTO transfer Paper and 3 x Clear DECAL Paper (6 pieces in total)

Used ceramics, glass, tiles, plastics, metal and any other items with a glossy surface finish 

The beauty of this product you DO NOT need to use an acrylic spray so it is ideal if you want to make your own printed mugs,plates etc..No specially coated mugs, no special inks and no restrictions on colour and size

OVERSEAS CUSTOMERS:

Please contact us prior to buying this product as shipping is $22 registered post ONLY.These charges are Australia post fees, you can look them up online on the Australia post website.

INSTRUCTIONS:

1. Print your image onto the glossy side of your decal paper (DO NOT mirror your image) using an inkjet printer. Allow to dry thoroughly.

2. Separate the translucent protective paper from the magic paper. Do not throw the translucent paper away.

3. Place the magic paper gloss side up on your table. Lay the decal paper printed side down on top of the magic paper. Place the translucent protective paper gloss side down on top of the decal paper.

4. Laminate your stack of three papers together on low speed and at low temperature.
Basic laminators can be bought for around $20 from most office supply and department stores.

5. Discard the translucent paper. Your decal paper and magic paper should now be fused together. Trim closely around your image - you can see it quite easily through the paper if you hold it up to the light.

6. Dampen the back of the decal paper (watermarked side) with a cloth until it becomes translucent. Wait around 15 seconds then gently peel the paper away completely.
Important: ensure you remove the watermarked decal paper only at this stage.

7. Quickly immerse the decal in a shallow dish of water to dampen the other side then position it, image side down, on your item, smoothing it down with your fingers and a slightly damp cloth to remove excess water.

8. Carefully slide off the backing paper and manipulate the decal into its exact position then continue to smooth it until it is water and air bubble free (the image for step eight shows the transfer with some minor creases and bubbles. This is only because the photograph depicts the removal of the backing paper before I have smoothed the decal. Rest assured that it does flatten out completely).

9. Finally, set the decal by either:
- Baking in an electric oven for 8 minutes at 150 degrees celsius
- Cooking in a microwave for 5 minutes on low
- Blowing with a hairdryer for 5 - 10 minutes

Massive thanks to thepaintedhive.blogspot for Kristine's feature on my decal paper :-)

I POSTAL CHARGES: