300 Second USB Sound Voice Recording Module W Motion Sensor AND Enclosure

Item number:

261010876566

Seller assumes all responsibility for this listing.

Last updated on 17 Jan, 2013 07:44:03 AEDST View all revisions

Item specifics

Condition:

Brand New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is available in a retail store, unless the item was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. See all condition definitions- opens in a new window or tab ... Read moreabout the condition

electronics123_com1

Visit my eBay store

Store Categories

Store home

This module connects to your computer via a USB cable (not included). Then use the free software to record up to 300 seconds of .wav files to it. The software is very powerful and will allow you to stack wave files and program pauses so the sensor can be used to trigger up to 200 different messages - or a different group of messages each time, up to 100 groups! (The messages or group of messages are played sequentially each time MOTION is detected). Comes with a built-in speaker. Requires 3 AA batteries (not included).

Features

Up to 300 seconds of re-recordable voice message (8K sample rate)
Includes 6 different playback settings including repeat and continuous playback
Use USB type-B male connector for direct plug into USB cable (not included)
Easy to transfer software for windows of .wav audio files
Choice of sample rates
300 seconds non-volatile recordable IC.
Operating Voltage 4.5V (3 x AA batteries not included)
Operating Current < 50 mA
Standby Current < 5 uA
Front push switch playback
55mm built-in speaker (included)

Dimensions: 65 x 94 x 26mm

NOTE: This unit will directly plug into a type "B" USB cable. A USB cable is required for recording.
NOTE: This unit will only record .WAV files. However, you can download a .mp3 file converter here: GoldWave v5 .mp3 file converter download
It is a very easy to use. Just open the sound file in this program, and save it as .WAV, and
select “PCM unsigned, 8 bit, mono” in the Attributes section.

If you are running Windows,
Click here to download WinRAR software (Which is what you will use to open the software itself, below:) For instructions on this download, click here.

Click here for software download for USB07M

Click here for video demonstration of software

Q1: Does message repeat when it finishes?
A1: There are many playback settings that can be selected. The options are as follows:
1) One Shot, Re-triggerable - Plays segment until another sensor is retriggered, then plays that segment. If nothing is on other segment, message stops. Message starts over and plays until end of message if sensor is retriggered again during playback (when sensor is retriggered, does not stop playback).
2) One Shot Non-Re-triggerable - Plays entire file even if sensor is retriggered during playback.
3) Level Hold, Play 1 cycle - Only plays as long as button is pressed down. Message will stop after one complete play or when button is released or if another button is selected. If another button is selected, message plays as long as button is pressed - one complete time.
4) Level Hold play repeat - Same as 3) except message loops until button is released.
5) One Shot, Re-triggerable, repeat - This one is dangerous! Message loops until another segment's button is pressed, then that segment will loop continuously unless you select a different trigger function (which you can do in the program). Yes, you can select a different playback function FOR EACH BUTTON.
6) Toggle On/Off - Playback stops when same button is pressed. Message will start from beginning when same button is pressed a third time. Also, if another button is pressed while first segment is playing, the new segment will play once through unless you press it's button again which makes it stop playing.

Q2: If the sensor is triggered repeatedly, will the message repeat?
A2: Yes & No. Usually the message will only play once. Button has to be released and pressed again for message to replay - unless you have selected #4 above "Level Hold Play Repeat." In this case, the message will loop until you release the button, then start from the beginning when you press the button again.

Q3: What happens if white sensor is activated again during playback of message?
A3: This depends on the mode that is selected, see Q1. Some modes stop the message - some start it over.

Q4: Does the recording get erased when the batteries are removed?
A4: No; it is non-volatile memory. Removal of the batteries will not erase the recordings.

Q5: How do I record 300 seconds at 16k?
A5: Unfortunately the unit can only record 300 seconds at 8k. It can record a maximum of 150 seconds at 16k. We have found that there is not much of a noticeable quality difference between 8k and 16k.

Q6: Should I use the 8bit mono unsigned or 16 bit mono signed?
A6: Either one is fine. They will both work and it shouldn't make much difference.

Questions and answers about this item

No questions or answers have been posted about this item.

Ask a question

02391

Seller assumes all responsibility for this listing.

Postage and handling

Postage cannot be calculated for your area. You can contact the seller for additional postage costs and services.

Posting cost cannot be calculated. Please enter a valid postcode.

Save on postage. This seller offers postage discounts on combined purchases for eligible items.

Item location: Columbiana, Ohio, United States

Posting to: Worldwide

Quantity:

Change country:

There are 374 items available. Please enter a number less than or equal to 374.

Select a valid country.

Postcode:

Please enter a valid postcode.

Please enter five or nine numbers for the postcode.

Postage and handling	To	Service	Delivery*
US $15.40	Australia	USPS First Class Mail Intl / First Class Package Intl Service	Varies for items posted from an international location Seller posts within 1 day after receiving cleared payment.
US $57.95	Australia	USPS Express Mail International^TM	Varies for items posted from an international location Seller posts within 1 day after receiving cleared payment.
US $125.00	Australia	UPS Worldwide Express^SM	Varies for items posted from an international location Seller posts within 1 day after receiving cleared payment.

* Estimated delivery dates include seller's handling time, and will depend on posting service selected and receipt of cleared payment. Delivery times may vary, especially during peak periods.

Domestic handling time
Will usually post within 1 business day of receiving cleared payment[newWindowTxt].

Return policy

Item must be returned within	Refund will be given as
30 days after the buyer receives it	Money Back

The buyer is responsible for return postage costs.

Refunds by law: In Australia, consumers have a legal right to obtain a refund from a business for goods purchased if the goods are faulty, not fit for purpose or don't match description. More information at returns - opens in a new window or tab.

Payment details

Payment method	Preferred/Accepted	Buyer protection on eBay
	PayPal Preferred

Immediate payment required for this item

Immediate payment of US $17.99 is required.

300 second USB sound / voice recording module w/ motion sensor and enclosure

Find out more about the Top-rated seller program - opens in a new window or tab