Details about Chrysler Valiant Charger Race or Targa Not R/T V8 Manual CAMSSee original listing
09 Sep, 2014 11:17:30 AEST
Ringwood East, Victoria, Australia, Australia
Used: An item that has been used previously. See the seller’s listing for full details and description of ... Read moreabout the condition
|For Sale by:||
|Engine Size (litre):||
|Type of Title:||
Clear (most titles)
|Date of Manufacture:||
Chrysler Valiant Charger.
6.0L 4 speed manual.
It was built in 1996 as an Improved Production (Club Cars) Race car.
It is NOT registered or roadworthy
Has not seen a track for 16 years.
Full 6 point roll cage welded in. (Met CAMS requirements in 1996)
One 5 point race harness.
6.0L / 360 Manual. High compression. KB pistons
Four wheel discs. Four spot calipers & VT rotors on the front. Balance bar master cylinders under dash
Genuine R/T 16:1 steering box.
HD (1.09") torsion bars.
Near new 15x8 supalites
Remote filter & oil cooler.
Tuned length headers
Factory Cast iron Hemi / V8 bell housing
Sintered button clutch
Close ratio (R/T) Transmission.
Adjustable spring hangers
Foam filled tank. Filler accessible from boot.
Battery in boot
Fresh paint. Pretty good body for a Charger. Rebuilt sub frame. Minimal rust. Shedded last 16 years.
Needs a couple of things to get it back race ready, or a lot of things to put it back on the road (Only major modification is cage would need to be cut out)
For this price it includes the following major spares:
(Track pack R/T E49) spax rear shock absorbers. (used, but I never used)
HD rear spring set (used, but I never used)
Rod end radius arms (used, but I never used)
Gearbox, single rail. Wide Ratio. Good working order. Has shift housing and drop bar.
Gearbox, Single Rail. (Unsure of ratios) Appears OK, No shift housing or drop bar.
Gearbox single rail. (Unsure of ratios) Parts (main shaft needle bearing surface damaged).
360 Short motor. Virgin bore. Needs rebuild. Not used for 20+ years
360 heads. Not j’s. Bare (I have valves and springs somewhere). Needs rebuild
360 Tunnel ram. EFI bosses, fuel rails and GM L76 injectors. Incomplete but close
Small block Mopar Performance cast aluminium rocker covers. (as cast, not polished)
4 speed tail shaft – standard. Needs rear uni.
4 speed tailshaft – aluminium (cut down fairlane) Not used.
4 speed bellhousing. Dellow Aluminium
Vk tail lights. Good condition
Full set of front end parts (ball joints & Bushes)
2 x timing case covers - used
1 x 40 amp alternator
1 x 55 amp alternator
Heated rear windscreen
Assorted clutch & pressure plates
Ported 265 head - Used.
Calipers, door handles, door hinges, upper control arms, clutch cross overs, and lots of little bits and any other valiant bit I can find. It’s a complete clear out.
I will not separate anything at this time.
Viewing welcome if you are serious. Message me first.
Terms. Cash. Bank cheque. Funds will be cleared before car goes anywhere.