Hello i am Mario keep your eye on this eBay selling site as you will see some great audio visual products sell for bargain prices
NAD 7240PE quality stereo receiver.
I don’t have to go on about how good vintage NAD sounds as we all know there reputation.
This is an awesome receiver with phono input and pre outputs so can be used as a pre amp.
Lots of current and lots of headroom makes this receiver a cut above the rest.
This unit is in excellent well looked after condition and functions perfectly
The 7240PE receiver consists of the 3240PE integrated amplifier, with its vast reserves of clean, solid power for the the wide dynamic range of modern recordings, plus an exceptionally sensitive digital tuner
Power Envelope design :
While the 7240PE is rated at 40 watts per channel of steady-state power, its +6 dB of IHF dynamic headroom means that its dynamic power for musical transients exceeds 160 watts per channel at 8 ohms and 200 watts/channel at 4 or 2 ohms. Even with long 200-millisecond tone-bursts, representing the full duration of musical notes and chords, the 7240PE produces an impressive 100 watts per channel
High-current output stage :
The 7240PE delivers up to 25 amperes per channel to ensure precise electromagnetic control of the speaker’s voice-coil, even with impedances as low as 2 ohms Impedance selector :
This rear-panel switch lets you optimize the amplifier’s operation to drive either low impedances (2 to 6ohms) or a single set of speakers with a true 8-ohm (or higher) impedance
Soft Clipping™ :
When the amplifier is driven beyond its rated power, NAD’s famous Soft Clip-ping™ M circuit gently limits the waveform and prevents the harshness that occurs in other receivers when the output transistors arc driven into saturation
Low-noise phono preamplifier : NAD’s phono pre-amp circuits feature accurate RIAA equalisation, correct interfacing with the complex impedance of the phono cartridge, very low noise and plenty of headroom to accommodate the highest-level peaks without distortion
Digital-ready inputs :
With overload-proof line inputs and low-noise circuits for volume and tone control, the 724OPE accommodates a dynamic range greater than 100dB, preserving the transparent clarity of the finest analogue and digital recordings
Bass EQ with infrasonic filtering :
The equalisation circuit boosts the deepest bass by 6 dB providing the sort of authentic bass “feel” that might otherwise require a costly separate subwoofer system. At the same time, a sharp infrasonic filter prevents excessive woofer-cone motion and minimizes the bass-muddying effect of turntable rumble, warps and tone arm / stylus resonances
Musically Effective Tone Controls :
Ordinary bass and treble control circuits intrude on the midrange; boosting the bass, for instance, makes vocals thick and boomy. In NAD receivers, the bass and treble controls do what their names imply : they vary the strength of the bass (the solid foundation, the musical beat) and the treble (the crisp detail, the airy brilliance) while preserving a neutral, accurate midrange response
Precise digital tuning : The tuner section of the 7240PE features sensitive dual-gate MOSFET front-end, a three-stage linear-phase I.F. circuit for sharp selectivity, a low-distortion quadrature detector, and a phase-compensated PLL multiplex decoder with wide stereo separation at all frequencies. Special filtering minimizes interference from SCA and RDS sub-carriers
FM Noise reduction :
NAD’s unique FM noise-reduction circuit eliminates much of the noise and distortion in weak FM stereo signals, a welcome improvement for any listener who can’t put up a roof antenna. With FM-NR, the 7240PE needs only half as much signal strength as other receivers to obtain good quieting. The thoughtful engineering of this NAD receiver is evident in the design of its logical, easy-to-use controls -and in the deliberate avoidance of glitter, gimmicks, and frills. When you choose an NAD receiver, you are investing in quality behind the front panel - in advanced circuit design, selected parts, oversize high-current transistors, exacting quality control, and solid construction for long-term reliability. The proof is in the listening
Vintage : 1986 to Nov 1989 model
PRE-AMP SECTION :
Phono input : Input impedance (R and C) 47k ohm / 100pF
Input sensitivity : 1kHz 3.2mV ref. 40W
Signal / Noise ratio (A-weighted with cartridge connected) : 75dB ref. 5mV
THD (20Hz to 20kHz) < 0.04% RIAA response accuracy [20Hz to 20kHz] : ±0.5dB
Line level inputs : Input impedance (R and C) 40k ohms / 100pF
Input sensitivity [ref. 40W] : 160mV
Maximum input signal : > 10V
Signal to Noise ratio [A-weighted ref 1W] : 88dB
Frequency response [20Hz to 20kHz] : ±0.5dB
Infrasonic filter : -3db at 15Hz, 24dB/octave
THD : 0.01%
Line level outputs : Output impedance : Pre-amp: 600ohms Tape Source Z + 1kohms Phones : 220ohms
Maximum output level : 12V Tape : 8V Phones > 10V into 600ohms, > 500mV into 8ohms
Tone controls : Treble : ± 7dB at 10kHz Bass : ±10dB at 50Hz, Bass EQ : +3dB at 70Hz, +6dB at 40Hz
POWER AMP SECTION :
Continuous output power into 8 ohms 40 Watts (16dBW)at rated distortion (THD 20Hz to 20kHz) : 0.03%
Clipping power [maximum continuous power per channel] : 50W
IHF Dynamic headroom at 8 ohms : +6dB
IHF dynamic power [maximum short term power per channel] : 8 ohms 160W (22dBW), 4 ohms 200W (23dBW), 2 ohms 250W (24dBW)
Damping factor [ref. 8 ohms, 50Hz] : > 50
Input impedance : 22kohms / 880pF Input sensitivity (for rated power into 8 ohms) : 1V
Frequency response : 6Hz to 50kHz +0dB, -3dB
Signal to noise ratio [ref. 1W] : 100dB ref. rated power : 116dB with THD (20Hz to 20kHz) < 0.03%
FM TUNER SECTION :
Input sensitivity : Mono -30dB THD + Noise : 10.3dBf [1.8µV/300ohms]
Mono 30dB S/N : 14.2dBf [2.8µV/300ohms] Stereo 50dB S/N : 36dBf [34µV/300ohms FM NR off], FM NR on: 29dBf [16uV/300ohms]
Stereo 60dB S/N : 47dBf [120µV/300ohms]
Capture ratio [45 - 65dBf] : < 1.5dB
AM rejection [45 - 65dBf] : > 60dB
Selectivity, alternate channel : 65dB Image rejection : 70dB IF rejection : 90dB
Harmonic distortion : Mono: 0.09% Stereo: 0.09%
Signal to Noise ratio : Mono: > 80dB Stereo: > 75dB
Frequency response : 30Hz to 15kHz [±0.5dB] Channel separation at 1kHz : 50dB
AM TUNER SECTION :
Usable sensitivity : 300µV Selectivity : 35dB Image rejection : 50dB IF rejection : 35dB
Signal to Noise ratio : 45dB Harmonic distortion : 0.5%
Remote : No NAD Link : No
Dimensions [W x H x D]: 420 x 108 x 380mm Weight : 7.5kg, packed weight : 9kg
Tuning range: FM, MW
Power output: 40 watts per channel into 8Ω (stereo)
Frequency response: 20Hz to 20kHz
Total harmonic distortion: 0.03%
Damping factor: 50
Input sensitivity: 3.2mV (MM), 160mV (line)
Signal to noise ratio: 76dB (MM), 88dB (line)
Speaker load impedance: 2Ω to 8Ω
Dimensions: 420 x 108 x 380mm
Weight: 7.48kg NET
Over the past 22 years, i have been involved in the Audio Visual industry.
In that time - and to the present, I owned a retail store, which I developed into Successful company and was well regarded in the industry.
My newest venture, being h.i.f.i_online, selling quality, middle to top end pre-loved and new audio visual products on ebay at bargain prices.
My office is centrally located in Mascot, (10 minutes from Sydneys CBD), and all products sold, are backed up by a 45 day warranty. All items are checked before listing but I will not take responsibility for items damaged in post.
Keep an eye on my selling items, as you will see a great deal of high-end, mid-end, as well as collectable items coming up in the future.
I will attempt to put new items on this site, on a daily basis, and take pride in offering as much information as possible - including clear photo shots of each product.
I look forward to servicing you, and seeing you come back time and time again.
Terms and Conditions:
*Local pick up is welcomed COD IS FOR LOCAL PICK UP ONLY .
*A handling fee will apply, should you wish to have your item securely packaged and sent out to you. I do employ some one to pack items securely and purchase bubble rap, boxes, tape and labels which is not a cheep process as you could imagine.
*A courier company will be used for items that are to large for post. ( you are welcomed to use your own courier for pick up. A $10 handling fee will apply for packing). ALL ITEMS PACKED WELL BUT I WILL NOT BE HELD RESPONSIBLE FOR DAMAGED ITEMS BUY FREIGHT WHEN SIGNED FOR.
*All second hand items come with a 45 day full warranty (unless stated otherwise) we do sell new stock which comes with the manufacturers warranty and will be stated in the auction.
*I welcome your questions, requests and feedback of my products and site, and hope that you enjoy using it, as much as we enjoy putting it together.
*I can be contacted by phone on PH. 0423541633 or (02)93415525 MY HOTMAIL EMAIL ADDRESS IS DOWN SO PLEASE EMAIL THROUGHT THE EBAY SYSTEM OR CALL THE NUMBERS LISTED IF YOU NEED TO CONTACT ME.