Details about Power over Ethernet POE 48V injectorSee original listing
22 Jan, 2015 18:08:08 AEDST
Brisbane, Queensland, Australia
Brand New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is ... Read moreabout the condition
ITEM CODE: PSE4801
POE voltage injector which enables the insertion of a 48V DC voltage, 0.5 A, to a CAT5 or CAT 6 cable. Has a LED to show the presence of applied voltage.
Now with Australian Plug to IEC mains lead included.
Works on either 50 or 60Hz.
Mains input voltage range 100-240V
Not quite what you are looking for or you are slightly unsure? Ask us a question.
We can also offer quantity discounts. Just ask us a question about this.
This unit conforms to IEEE standard and uses:
pins 4&5 for the positive.
pins 7&8 for the negative.
Note some older equipment does not conform to the IEEE standard. See:
However, if you are reasonably sure you know what you are doing you can often get around these issues by making up a special ethernet cable with certain leads crossed over internally. You may want to check with the equipment manufacturer before purchase.
Input voltage: 90VAC ~ 280VAC, 47Hz ~ 63Hz
Maximum output power: 40W
Output voltage accuracy:-48VDC ± 2%
Load regulation:-48VDC ± 1%
Operating ambient temperature range: -5 ℃ ~ +55 ℃
DC output broadband noise voltage: 3.4kHz ~ 150kHz ≤ 50mv
two RJ-45 ports support 10/100Mbps Link Rate
Multiple orders on RFShop Australia are aggregated for postage. The total postage will be no more that the cost of the bulkiest / heaviest item.
RFShop on Ebay:
(you might want to bookmark this link to find us easily next time)