This amount includes applicable customs duties, taxes, brokerage and other fees. This amount is subject to change until you make payment. For additional information, see the Global Shipping Program terms and conditions- opens in a new window or tabThis amount includes applicable customs duties, taxes, brokerage and other fees. This amount is subject to change until you make payment. If you reside in an EU member state besides UK, import VAT on this purchase is not recoverable. For additional information, see the Global Shipping Program terms and conditions- opens in a new window or tab
NEED TO PROTECT YOUR STAND UP PADDLE BOARD FROM PADDLE DAMAGE AND OTHER KNOCKS
CLEAR RAIL PROTECTION TAPE IS THE ANSWER
CAN BE APPLIED WET OR DRY
HIGH PERFORMANCE CLEAR 3M ADHESIVE FILM 60 mm WIDE AND 0.50 THICK
Kit Includes . Handy Phone Carry Case
2 x 3m Surface Wipes
2 x 2.00mtr lengths of 60mm Rail Tape (tapered front ends)
Instructions Included (dry only)
For Wet Installation (Best Results)
·Squeegee or Credit Card
·1 small spray bottle
·Isopropyl Alcohol (70% Rubbing Alcohol from any drugstore)
·Soft lint-free cloth
Read instructions before application. (Wet installation only)
·Cleaning Solution: In 1 spray bottle combine 3 parts water to 2 parts alcohol (60/40) and a small drop of baby shampoo to create the (Slip solution).
·Prepare surface with alcohol/water solution and wipe with a clean, soft cloth.
·Install at temperatures between 65°F and 90°F. Do not apply in direct sunlight or windy conditions. Clean hands and keep fingers wet during installation.
·Verify size and placement of each part prior to removing liner.
·Wet surface and fingers using Solution. Remove liner from first piece to be applied. Wet the adhesive side with Solution and position in place.
·Apply additional Solution between surface and adhesive to allow piece to move easily. Lift the material from one side and spray - be careful not to stretch the material.
·Position film in place. Spray a small amount of solution in the centre of the piece between the surface and the adhesive. Make a small vertical stroke with the squeegee down the centre of the material. The part is now “tacked” to the surface and will not move freely.
·Lift one end of the material back to the anchor and spray the adhesive side of the material with the solution and reposition the film.
·Wet the top surface of the film, then using your squeegee make short overlapping strokes from the middle to the material edge (rewet the material surface as needed). Use firm pressure to avoid leaving water or air bubbles under the material.
If any area around the edges has “lift”, wrap a paper towel around your squeegee and go over the edges again. This will absorb the moisture around the edges that interferes with adhesion.
(estimated and based on max bid)To be provided at checkout
Your max bid:
Your max bid:
By clicking Confirm bid, you commit to buy this item from the seller if you're the winning bidder.
By clicking Confirm bid, you are committing to buy this item from the seller if you are the winning bidder and have read and agreed to the Global Shipping Program terms and conditions - opens in a new window or tab. Import charges previously quoted are subject to change if you increase you maximum bid amount.