Vintage Electrical Transformers

I have taken close up photos to see if these suit your needs. I will not label as a gift etc.

Secondary 4, 8, & 16 ohm. 15 watt SE. upgrade to 125A35A, 125A3A, 022905.

Equivalent to 125A10B & 022913. 2-13/16" (71.5mm) mounting centers.

Model: EE14. The spacing between the two needles is 5.0mm, 0.7mm rough for the pin. Frequency Type: High Frequency. Size: about 13mm x 11mm x 6mm.

TYPE C57 - DATED 1969.

AC impedance : EI14 600 : 600 Ohm. The primary and secondary windings are tightly coupled, there is sufficient pass frequency band, the original winding inductance is large, the leakage inductance is small, can reduce the influence of the hysteresis loss.

Equivalent to 125A1A, 022640, 041318. Deluxe Reverb. 3-1/8" (79mm) mounting centers.

TYPE C27 9500.

It has been tested at 240VAC by joining pins 9 & 10, Active to pin 1 and Neutral to pin 2. The base mounted stud mounting nuts are supplied with it.

TYPE C26 5000 CT/ 3-5.

The primary windings are 0-103.5-115-126.5VAC and the secondary windings are 0-6.3VAC at 7.5A, 0-6.3VAC at 0.6A, 0-6.3VAC at 1A, 0-6.3VAC at 0.15A, 0-1950VAC at 3ma and 0-6.3VAC at 0.9A. The mounting nuts are included.

Model: EE14. The spacing between the two needles is 5.0mm, 0.7mm rough for the pin. AC impedance : 1300:8.

Primary is 0 - 115V - 200V, Secondaries are 0 - 6.3V @ 0.9A, 0 - 6.3V @ 0.45A and 0 - 5V @ 5.6A. It can be operated from 400Hz to 1100Hz. The case is 13cm x 10cm x 10cm. The black paint finish is a bit flakey in places.

This would be most suitable for Robotics applications. The face is 12cm x 12cm and it is 12cm deep.

AC impedance : EI14 600 : 600 Ohm. The primary and secondary windings are tightly coupled, there is sufficient pass frequency band, the original winding inductance is large, the leakage inductance is small, can reduce the influence of the hysteresis loss.

The unit had been dropped and the casing physically broken but the innards appear to be intact.

The Primary is made up of two 120 volt windings which are strapped at the selection plug for 240V. There are 3 secondaries, one of 12V, one of 23V and a centre tapped one of 36V, so a very usefull combination.

The case is 70 x 75mm and is 110mm high.

Model: EE14. The spacing between the two needles is 5.0mm, 0.7mm rough for the pin. Due to the difference between different monitors, the picture may not reflect the actual color of the item. Durable and long service life.

Primaries are 0 - 115V, 0 - 115V, Secondaries are 0 - 24V, 0 - 15V and 8V - 0 - 8V. Being from a computer monitor, the total power would be about 100Watts. The case is 15cm x 13cm x 13cm. The black paint finish is a bit flakey in places.

Model: EI14. AC impedance : EI14 600 : 600 Ohm. Inductance : 290mH (±20%). Alternating-current impedance value : 600. DC resistance : 135(±%). Color: Red. Secondary coils : 800 turns. Primary coils : 800 turns.

Type:Step Down Converter 300W 230V To 110V.

Trimax interstage / isolation audio transformer 10K to 10K centre tapped.

Buying speaker only.

MAZDA ENGINE CODE CHECKER UNIT CA-1. DUE TO UNFORTUNATE CIRCUMSTANCES. Trading Hours (8.30 - 4.00) Mon - Fri.

RX - FT560 Parts. RX- FT560 parts. Boombox Panasonic. Upgrade your boombox or fill in the missing pieces on your exsisting system with these ​Panasonic. Parts Consisting of The picture below is model these parts are from .

You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. Jaycar Electronics does not accept any liability beyond this for consequential loss.

1/4" (6.35mm) T/R/S and female XLR-type input (with parallel 1/4" and male XLR-type output). Didn't find what you want here?. Product warranties are governed by the respective manufacturers or suppliers warranties.

AC impedance : EI14 600 : 600 Ohm. The primary and secondary windings are tightly coupled, there is sufficient pass frequency band, the original winding inductance is large, the leakage inductance is small, can reduce the influence of the hysteresis loss.

Model: EE14. The spacing between the two needles is 5.0mm, 0.7mm rough for the pin. Size: about 13mm x 11mm x 6mm.

Model: EE14. The spacing between the two needles is 5.0mm, 0.7mm rough for the pin. Size: about 13mm x 11mm x 6mm. AC impedance : 1300:8. Frequency Type: High Frequency.