CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Car Amplifiers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Car Amplifiers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
I bought the XR600-1 to replace my huge, aging KAC-9152D which is running a pair of KFC-XW10's, it was just time to free up space in my truck for a larger capacitor. While my old amp is technically more powerful the XR600 makes much better use of available current which makes cleaner power, cooler running, better heat distribution and does it with a very small form factor. Supplied with input from my 994S this little amp easily puts my old one in its place in history. The actual output sounds better all around and with there is absolutely no discernible difference in available power except that this amp has it to spare. Running Kenwood with Kenwood x2 is where you will really notice everything the brand does so well. By using the speaker selection/ setting menus on the Kenwood headunit you are able to set your amp up at near full level output and use the headunit to dial it back which is perfect for anyone with limited access to the amp controls once installed. As an example my unit is running my subwoofers at -10 which obviously means it has a long way to go before even getting into the + levels. All that and still just absolutely booming, this is one great little amp. I see no signs of previous use on this refurbished unit, it's been re-boxed by Kenwood but everything looks and sounds like new. All the necessary bits and pieces (3 different size Allen wrenches, 4 mounting screws, etc.) required for installation are there. Note that there are no speaker line inputs so you will need to have an RCA line input from your headunit but you can daisy chain amplifiers through this amp if you do not have a specific subwoofer output. In that case you could run another amplifier (rear speakers) through the RCA out and use the amps low pass level to determine the audio level output from this amp while still sending full range audio to the other amplifier or speakers. Now I just need to replace my old F240 amp, I attached pictures showing the size difference just because its comical how much smaller it really is. Enjoy!Read full review
Verified purchase: Yes | Condition: Refurbished
I got this amp because I was looking for a mono 600 watt and it was a good price. I have it hooked up to a JL 10w6v3 in a spec built box. It sounds great.
Verified purchase: Yes | Condition: New
This small footprint amplifier is pushing a 13" 2 ohm JL sub in a custom fiberglass stealthbox. Unbelievable power and response. Perfect combo of value and performance.
Verified purchase: Yes | Condition: New
Came brand new like it was listed with everything available to be ready to setup. It's a small amp but not that big like other amp.
Verified purchase: Yes | Condition: New
Perfect small, just enough to balance out all my other speakers.
Verified purchase: Yes | Condition: New
