 |
Aluminum in car bodies doesn't rust, but it sure can get scratched just as easily as steel. These are easy to install, instructions easy to read, great material. You do not have to drill, there are holes for mounting and secure fit. The shape of these is such that the lip at the wheel well opening secures the liner and four screws keep it from going any place. Foremost, if you are installing on a previously driven vehicle, road debris accumulates on the lip inside the wheel well and will interfere with proper fit. A soft brush and water will clean anything hiding up there. Installed both sides in about 40 minutes. And they 'finish' the wheel wells.
Verified purchase: Yes | Condition: New
The Pros are the material is good The cons are the fit. It is not a quality product. I thought Husky had good quality. The holes were not drilled in the correct location, but the factory did realize this and corrected the location, but the extra holes still exists. I am trying to keep dirt out! The edges were very sharp and jagged. Cut my fingers installing the item.The holes had to be deburred to put the screw thru. My suggestion is to pay the small additional cost to get the original Ford covers.
Verified purchase: Yes | Condition: New
Great product, fit right, works as it should. Quick install, took about 10 minutes per side. Made of heavy duty plastic. So far it's keeping out dirt and debris from bed and rear frame. Also, cleans up the look the of the rear wheel wells nicely. Quick shot with the hose cleans it out fast. Overall, happy with the results and function. The truck should have come from factory with these!
Verified purchase: Yes | Condition: New
Everything matched up well on the Drivers Side. Passenger Side was another story. Had to do some trimming for the PS and much, much more effort was required to get the PS holes to match where they needed to be screwed to the truck compared to the DS installation. Took about an hour or more to install for a person not so mechanically inclined. These cover more area of the inside wheel well and bed and make the truck look more finished.
Verified purchase: Yes | Condition: New
A little tricky to install but with a little patience and some plastic door panel tools you can guide the liners inside the fender lip. Just jacked up the body for clearance, didn't even have to take the wheel off. Great fit and quality. Very happy.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Splash Guards & Mud Flaps
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
