About
All Feedback (388)
ylzj433 (226)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
thebostoniancollectorscompany (43085)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
lorber588 (13038)- Feedback left by buyer.
Past 6 months
Verified purchase
Very reliable buyer, would gladly sell to again
lorber588 (13038)- Feedback left by buyer.
Past 6 months
Verified purchase
Very reliable buyer, would gladly sell to again
lorber588 (13038)- Feedback left by buyer.
Past 6 months
Verified purchase
Very reliable buyer, would gladly sell to again
theolivine (4517)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy,pleasant transaction.Excellent buyer.A+++++++
Reviews (7)
21 November 2018
Solid performer
Well-manufactured as one would expect from Browning. Easy to install right where the top plate / rear sight mount over the slide is located. Two screws to remove (the original screws are in REALLY tight), remove the old sight mount, orient the new scope mount and replace the screws with a little Locktite. Tighten the screws firmly. Let the Locktite dry. Piece of cake.
I mounted a CVLife Red / Green dot sight and tightened the sight screws on the new scope base and off to the range. After sighting in the red dot, was consistently shooting a 3 inch diameter circle at 25 yards and putting all the shots through a 1 1/2" hole at 10 yards. (I'm still learning trigger control and not a very good shot.) The sight was holding onto the scope base just fine. Threw 400+ rds down range without any variation.
My conclusion is that the scope base provides a solid mounting rail for a sight just as it was designed to do on a Buck Mark pistol. This is my second scope base on two different model Buck Mark pistols, a Standard URX and a Plus UDX, with the same solid results.
27 January 2021
Maybe jump start, but....
2 of 2 found this helpful Batteries do not seem to have the advertised capacity of 20,000mAh. I have a 12,000mAh Li rechargeable jump start battery that seems to have a much higher capacity. It's cheap and does work on 12v devices, but the charge seems to be dissipated quickly.
I have not used to for jump starting, maybe it would be OK for a couple of jump starts between charges, but not for operating 12v slow-discharging into 12v devices.
10 December 2009
HTPC Video Card
Using this card in an HTPC with very good results in Windows7. Works great for 720p, have not tried 1080p. Runs cooler than I expected.