Unbranded Server Components

1 x PCI 4ports SATA Raid Card. Supports RAID 0 (Striping), RAID 1 (Mirroring), RAID 0 1, RAID 5 and RAID 10. 4 Internal SATA ports supporting/connect up to 4 SATA devices. ROM BIOS supports RAID setup and Boot Features.

Support RAID 0, RAID 1, RAID 5, RAID 0 1 mode, support JBOD. Support RAID 0, RAID 1, RAID 5, RAID 0 1 mode, support JBOD. Supports PCI 32-bit bus; Bus speed of 33MHz / 66MHz; PCI 2.3 Standard. 1 x PCI to 4 Port SATA RAID Card.

System disk and PCIE to SATA3.0 adapter card connection conditions and solutions Support Interface: USB3.0 TO SATA 22PIN. Supports two SATA. Bus interface. Support native command queue (NCQ). 3, the above two conditions are available, if you still can not start, or repeatedly restart, then the motherboard hard drive interface and our adapter card conflict, the solution is to enter the motherboard BIOS, the motherboard's hard disk interface options set to Disabled, save and restart to boot the system.

Support RAID 0, RAID 1, RAID 5, RAID 0 1 mode, support JBOD. Support RAID 0, RAID 1, RAID 5, RAID 0 1 mode, support JBOD. Supports PCI 32-bit bus; Bus speed of 33MHz / 66MHz; PCI 2.3 Standard. 1 x PCI to 4 Port SATA RAID Card.

Note: The color of the item may vary slightly due to photography and your own computer Features & Specification: Stable and reliant Silicon Chipset SIL3114 PCI specification revision 2.3 compliant w/ 32-bit 33/66Mhz host interface Serial ATA specification revision 1.0 compliant Data transfer rate up to 150MB/s. (1.5Gbps) Connect up to 4 SATA drives Plug & Play connection Software application included Raid Function: Integrated SATA Transport, Link logic, and PHY layer Supports 4 Independent Serial ATA channels Supports RAID 0, 1, 5, 0 1, JBOD12 Supports 256-byte transmit and receive FIFOs .

2pcs 36Pin Mini SAS SFF-8087 CBL-SFF8087 SAS TO 4 SATA Data Cable. - Mini SAS SFF-8087 to 4 SATA Cable. 2 x Mini SAS to 4 SATA Cable. - 4 SATA 7 pin female connectors for drives.

You will be a surprised that bare LCD will be in good use, and no longer be wasted. This kitcompatilbe with M170ETN01.1 only, NOT for other panel. Specially design kit for M170ETN01.1, driver is pre-installed.

Features: Embedded version Mega 2560 CH340G / ATmega2560 - compatible with Mega 2560 motherboard. Based on Atmel ATmega2560 microcontroller and USB-UART interface chip CH340G. The circuit board is compact in size and 38x55mm in size. This is a good solution to make your final project on the welding prototype board..

Support TTL signal output. AT070TN94, etc., universal 50PIN interface TTL LCD screen. Relative humidity: 80%. Do not disassemble the module. Our goal is. Can support We will be responsible for. Can’t be pressed and distorted.

2pcs 36Pin Mini SAS SFF-8087 CBL-SFF8087 SAS TO 4 SATA Data Cable. - Mini SAS SFF-8087 to 4 SATA Cable. 2 x Mini SAS to 4 SATA Cable. - 4 SATA 7 pin female connectors for drives.

System disk and PCIE to SATA3.0 adapter card connection conditions and solutions Support Interface: USB3.0 TO SATA 22PIN. Supports two SATA. Bus interface. Support native command queue (NCQ). 3, the above two conditions are available, if you still can not start, or repeatedly restart, then the motherboard hard drive interface and our adapter card conflict, the solution is to enter the motherboard BIOS, the motherboard's hard disk interface options set to Disabled, save and restart to boot the system.

P/N: 00E7600 L38552. 1 Tray caddy. It is compatible with the following servers with 2.5" hotswap drive bays. We strive for 5-star service by stating upfront our policies and will try our best to solve the problems you have.

This kit is for bare LCD M170ETN01.1 ! Input power of 12V,3A. Plug&play kit, no need soldering. Your bare LCD will be of good use, and no longer be a waste. Connecting cable s and power adapter are NOT included.

SERVER RACK 4 FAN COOLING UNIT. Fan Size -120mm x 120mm. Item as images. Size - 550mm x 420mm.

5PCS Toothbrush Head Cover Case Storage Travel Hiking Brush Cap Clean Box Holder. Night Mouth Guard for Teeth Clenching Grinding Dental Bite Sleep Aid Silicone. Output: 12V DC 1A (1000mA). Anti Stop Snoring Nose Clip Nasal Dilator Night Sleeping Aid Magnetic Snore Free.

Fairly generic PCI SCSI adaptor card with internal and external connectors. Internal cable included.

Note: The color of the item may vary slightly due to photography and your own computerFeatures & Specification: Stable and reliant Silicon Chipset SIL3114 PCI specification revision 2.3 compliant w/ 32-bit 33/66Mhz host interface Serial ATA specification revision 1.0 compliant Data transfer rate up to 150MB/s. (1.5Gbps) Connect up to 4 SATA drives Plug & Play connection Software application included Raid Function: Integrated SATA Transport, Link logic, and PHY layer Supports 4 Independent Serial ATA channels Supports RAID 0, 1, 5, 0 1, JBOD12 Supports 256-byte transmit and receive FIFOs .

Type: 240 -Pin DDR3. Speed: DDR3 1333 MHz (PC3-10600R). Capacity: 4GB. 4GB PC3-10600R server ram x 1. Manufacture by Samsung,high quality item. New Arrival. for our request andwe hope you can understand !

Max Output Power 380W.

Note: The color of the item may vary slightly due to photography and your own computerFeatures & Specification:   Feature: Stable and reliant Silicon Chipset SIL3114 PCI specification revision 2.3 compliant w/ 32-bit 33/66Mhz host interface Serial ATA specification revision 1.0 compliant Data transfer rate up to 150MB/s. (1.5Gbps) Connect up to 4 SATA drives Plug & Play connection Software application included  .

Features: 1.Stable and reliant Silicon Chipset SIL3114.  2.PCI specification revision 2.3  compliant w/ 32-bit 33/66Mhz host interface. 3.Serial ATA specification  revision 1.0 compliant. 4.Data transfer rate up to 150MB/s. (1.5Gbps). 5.Connect up to 4 SATA drives. 6.Plug & Play connection.  7.Software application included.  .

PFC harmonics compliance: IEC1000-3-2 /EN61000-3-2 standards. - Power Factor Correction: Active PFC 99% typical. - Ripple / noise: 1%. - Zero minimum load on 3.3V rail. - Efficiency, 100-120VAC, full load: 80% typical.

Features: 1.Stable and reliant Silicon Chipset SIL3114.  2.PCI specification revision 2.3  compliant w/ 32-bit 33/66Mhz host interface. 3.Serial ATA specification  revision 1.0 compliant. 4.Data transfer rate up to 150MB/s. (1.5Gbps). 5.Connect up to 4 SATA drives. 6.Plug & Play connection.  7.Software application included.  .

Power Factor Correction: Active PFC 99% typical. - Low ripple & noise. - Ripple / noise: 1%. - Load regulation: /-5% typical. - MTBF, full load @ 25℃ amb. : >100K hours. - Short circuit protection on all outputs.

Perfectly suitable to BTB Ant S5 S7 S9 A6 A7 L3 R4. Equipped with 38cm cable, use conveniently. 6 pin interface design. Max power output up to 1800W. Suitable for miner mining and other activities.

Supports RAID 0 (Striping), RAID 1 (Mirroring), RAID 0 1, RAID 5 and RAID 10. 1 x PCI 4ports SATA Raid Card. 4 Internal SATA ports supporting/connect up to 4 SATA devices. ROM BIOS supports RAID setup and Boot Features.

PFC harmonics compliance : IEC1000-3-2 /EN61000-3-2 standards. - Power Factor Correction : Active PFC 99% typical. - Zero minimum load on 3.3V rail. - Efficiency, 100-120VAC, full load : 80% typical.

Note: The color of the item may vary slightly due to photography and your own computer Features & Specification: Stable and reliant Silicon Chipset SIL3114 PCI specification revision 2.3 compliant w/ 32-bit 33/66Mhz host interface Serial ATA specification revision 1.0 compliant Data transfer rate up to 150MB/s. (1.5Gbps) Connect up to 4 SATA drives Plug & Play connection Software application included Raid Function: Integrated SATA Transport, Link logic, and PHY layer Supports 4 Independent Serial ATA channels Supports RAID 0, 1, 5, 0 1, JBOD12 Supports 256-byte transmit and receive FIFOs .

Raid Function Serial ATA specification revision 1.0 compliant. Supports RAID 0, 1, 5, 0 1, JBOD12. PCI specification revision 2.3 compliant w/ 32-bit 33/66Mhz host interface. Supports 4 Independent Serial ATA channels.

Our supported products includes IT Hardware Buyback/Trade in program. Sourcing hard to find parts. We are the spare parts specialists and assist you with part numbers and cost effective upgrades. Spare parts distribution.

Raid Function Serial ATA specification revision 1.0 compliant. Supports RAID 0, 1, 5, 0 1, JBOD12. PCI specification revision 2.3 compliant w/ 32-bit 33/66Mhz host interface. Supports 4 Independent Serial ATA channels.

Features:100% brand new and high qualityThe complete Passive Power over Ethernet Kit contains two pieces - INJECTOR and SPLITTER. It is suitable for using with products that basically do not support Power Over Ethernet. Passive Power Over Ethernet SET is applicable for wide range of network products such as Access Points, Routers, IP cameras, modems, switches, embedded computers or other network devices. Product Properties:Type: POE Splitter CableWire core material:Copper wireSheath Material:PVCUse for: POE AdapterDC Input Voltage:UP to DC 12VDC Output Voltage:UP to DC 12VMax Output Current 1.5A-2A MaxSpecifications:Color: Black, WhiteMaterial: PlasticWire length: Approx. 18cmInjector: RJ45 Male Power In to RJ45 FemaleSplitter: RJ45 Female to RJ45 Male P.

Supports RAID 0 (Striping), RAID 1 (Mirroring), RAID 0 1, RAID 5 and RAID 10. 1 x PCI 4ports SATA Raid Card. 4 Internal SATA ports supporting/connect up to 4 SATA devices. ROM BIOS supports RAID setup and Boot Features.

Power Capacity: 500 Watt / 563 VA. 80 PLUS Certification: 80 PLUS Platinum. Input Connectors: Power IEC 60320 C14. Note: This order will be dispatched from our Sydney Warehouse.

4GB SERVER RAM.

Features: The error of the voltmeter with a voltmeter is ( 0.1V) and the range is 0-40V. (Note: Input voltage is less than 4V, on-board voltmeter does not work and does not display). Input or Output Voltage Measured by Unique Light-touch Key Switching with Indicator Display. With terminal, it is easy to use without soldering iron, and retain the connection point of welding wire...

Features: Secure digital memory card interface works with FAT16 or FAT32 formatted cards. 3.3v level shifter circuitry prevents damage to your Secure digital memory card. Real time clock (RTC) keeps the time going. The battery backup lasts for years. Included libraries and example code for both Secure digital memory and RTC mean you can get going quickly Prototyping area for soldering connectors, circuitry or sensors..

Support RAID 0, RAID 1, RAID 5, RAID 0 1 mode, support JBOD. Do not dismiss your dream. Support more than 137 GB capacity hard disk (48-bit LBA). Supports PCI 32-bit bus; Bus speed of 33MHz / 66MHz; PCI 2.3 Standard.

2X(PAR T# 656364-B21. SPARE # 643933-001 / 660185-001. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. ).