Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Table Saws
it's a stong steal though mine was little bit bent the side but useable and easy fix. ryobi did a bad job in design it should have side mounts to fit more secure.. but easy to remove and press down install. fit latch cloest side first then press down back side of saw and clips right in, fits the rts10g .. funny no one has mentioned that there are two series the rts 10 and rts 10 g both take same plate. O not sure what to put as pwerful .. but it's a good plate. I did try ,make my own but without the original i only managed to make the fit but the material i used was too thick. any way it works this plate and that is the important thing ty.
Verified purchase: Yes | Condition: New