 |
On cutting 10mm Perspex, it chips badly, on the upcut. no matter what speed setting on my 600W jigsaw. If you switch to a slight oscillation on the blade, it still chips. The only way I could work round this was to overcut buy say 3mm then USE a planer on a smooth pass. Do fit a new blade before work proceeds.
Verified purchase: Yes | Condition: New
Needed it for cutting 3mm Axgard, something I knew nothing about and had never previously used. I followed manufacturers instructions/advice to the letter and the end result was brilliant.
Verified purchase: Yes | Condition: New
A good product didn't get a chance to test them because they didn't fit my jigsaw (my mistake) but my friend is happy with them
Verified purchase: Yes | Condition: New
works well and does the job a very good buy
Verified purchase: Yes | Condition: New
good value - works really well on a difficult material
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
