CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Lens Adapters, Mounts & Tubes
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Lens Adapters, Mounts & Tubes
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
This adapter is very affordable and it functions well (it doesn't have much to do). One minor defect is the fit of the hex key (Allen wrench) in the adjustment screws holding the threaded, M42 portion of the adapter (two of my four Fotasy adapters needed the alignment adjusted when received). The hex key appears to be too small for the hex sockets, so it tends to slip, rather than turn the adjustment screws. Angling the hex key helps, and adjusting the alignment of the adapter only needs to be done once (a 1 minute job), so the consequence of this defect is relatively small. Overall, for less than $10, the adapter is a great value.
Verified purchase: Yes | Condition: New
It's a solid build and it works. But the design has an obvious flaw. After installing the lens, the aperture reading will be on the bottom side. I have to flip the camera everytime to check which f stop I'm using.
Verified purchase: Yes | Condition: New
The product is good, fits tightly to the Fuji bodies (Xe1 and Xt1 that I use). Focuses all lenses to infinity precisely. Has enabled me to make use of Zuiko 60mm f1.5, 25mm f4.0, 38mm f1.8, 100mm f3.5 and 150mm f4.0. Attached is a photo of Tree Swallow and House Sparrow using the adapter with Xt1 and Olympus PenFt Zuiko 100mm f4.0., Chipping Sparrow and Purple Finches using 150mm f4.0 and flowering Magnolia using 25mm f4.0.
Verified purchase: Yes | Condition: New
Well made and Allen key included for removing black flange disk. Check your lense for small pin which can hit the flange preventing the adaptor to fully fit to your lense. Would benefit from a manual showing how to make sure that the aperture scale is positioned at the top of the lense. If you have to remove the flange then leave the grub screws loose, line up the aperture scale and then tighten the screws.
Verified purchase: Yes | Condition: New
Bought these ceap adapter to mount my m42 lenses on my fuji xX-T2. Works like a charm. Good fit on to the camera and good fit with the lenses, Not much more to say really. Does what it is supposed to do. Kan also unscrew to take out ring whcih hinders some lenses from mounting well, but I have not tried these my self. Positiv: Well made Nice fit Cheap Negative: None
Verified purchase: Yes | Condition: New
