CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Receivers & Transmitters
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Receivers & Transmitters
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
The problem I have with this is that it needs much better usage instructions. They fail to mention that if you use this to control an item that is not powered by the main battery, a common ground wire needs to be connected between the 2 separate batteries or it will not work at all. Once that is done, it works great!
Verified purchase: Yes | Condition: New
This is a not real switch, no like a button, you need conect a extra cable to -. on ebay you can buy more cheap and better of this. more simple. and instructions no good.
Verified purchase: Yes | Condition: New
Great controller for any electrical equipment you might want to install in a RC plane, car, or boat. A little confusing on setting up the common ground between all the electrical components I used but, very easy to wire once you have that done. Works very well in my project and have ordered another one for another project. If you are looking on a way to control something with your RC transmitter then this is for you. Just wish the instructions were easier to understand and the pin connections printed on the controller could be printed off on a instruction sheet. Picture is of my sound system installed in a Pterodactyl flying bird controlled by the Turnigy controlled switch. High amp throughput is a +.
Verified purchase: Yes | Condition: New
great switch from an open channel on your receiver. Make sure the jumpers tabs are facing the right way, works great to control my lights and siren in my rc truck. One end to receiver and other end to what you want to control. YouTube turnigy receiver switch and siren for an easy tutorial.
Verified purchase: Yes | Condition: New
It works well. Running off an aux channel to run a rc bilge pump. I used a seperate battery which requires attaching ground from both batteries to each other so the switch will function. I ran a negative from my bilge batt plug to a slot on the rx solving the issue. Works like a charm.
Verified purchase: Yes | Condition: New
