Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Pullers & Extractors
Due to restoration project I know I will be needing these type of things. For what they are size's and quality good value. After using then I may update review if I remember.
Verified purchase: Yes | Condition: New
Not great hardly any tolerance for undoing the nuts. Very stiff to use. Thought buying this brand would be better. Bit disappointed
Verified purchase: Yes | Condition: New
The pullers were purchased with the intention that they were to be used to pull the front wheel bearings from a Mondo mark three hub carrier. After removing the hub carrier I found that there was not enough of a crank on the legs to circumvent the bearing housing: This was a pity, because the feet of the puller did fit into the gap between the hub and the carrier's bearing housing. The legs were too stiff to manipulate initially, requiring the nuts and bolts to be slackened; having done so however, one of the nuts came off, the bolt fell out and the leg fell off. I would suggest that 'nylock' nuts be fitted to all bolts, allowing a precise amount of slack without the loss of the pivot bolts. The pullers seem reasonably adequate for light to medium work; the fact is though that I have not had the opportunity to put tem to the test Read full review
Verified purchase: Yes | Condition: New
This is a traditional bearing puller set. I brought it to replace some pump bearings and it did the job with no hassle.
Verified purchase: Yes | Condition: New
Poor quality product. Waste of money (£10.05). I would not recommend it. Better spend few more quid and buy something better. I was trying to remove two different size bearings but the puller slides off. I asked friend to help me, he took his own puller (bit more expensive...£40) and job was done in few minutes without any issues.
Verified purchase: Yes | Condition: New