Good value BUT.....cavities are off-centered and the sprue plate required the edges cleaned up before use. Lee offered to replace it BUT...the cost of shipping ($10) adds 20% to the cost each time you have to send it back, hoping to get a good one. Why should the consumer have to pay shipping for their poor quality issues? Bullets produced from this mold shoot alright BUT....could be great if the mold made better bullets.
Verified purchase: Yes | Condition: New
I have to squeeze the handles tightly otherwise, there are some of the cavities that will not seal well. I have this same problem with the other Lee 6 cavity I have as well. There are also, 2 cavities that are hard to get the bullets out of no matter how much I smoke them. Other than these 2 aggravating blips, it works fine.
Verified purchase: Yes | Condition: New
i purchased one of these it was top value and I have used it and the quality of the casting has been very good if you were looking for a great quality bullet mould I would recommend any of this brands products .
Verified purchase: Yes | Condition: New
This 6 cavity mold for the flat nose 9mm is a great mold. I’ve had issues with the 12ga slug mold in the past so I was skeptical before trying this one, but once I gave it a chance it exceeded all expectations! Would recommend.
Verified purchase: Yes | Condition: New
I have been using Lee bullet molds for about 5 years now and have found the quality to be quite good the bullets work fine I cannot see spending the money on an RCBS anymore.
Verified purchase: Yes | Condition: New