Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other Printer & Scanner Accs
I have a Wanhao i3 V2.1 clone (Balco), and like most users, the power wires on the motherboard burnt out because they're not large enought to handle the current needed to heat the heat bed and the unit kept resetting. Prior to this my success rate was only ~25% because the 3D model would often lift off the heat plate during the print. Since installing this controller, my print success rate has been 100% which I attribute to the heat controller doing it's job correctly. My only gripe is that this module is much larger than some others so I needed to mount it on top of the motherboard enclosure at the rear but it's out of the way and I can see the LED light up when the temperature drops below the heat bed setting so I know that it's working (you can see the bed temperature raise again on the LED but it's nice to see the LED). The heatsink is huge so will have no problems handling hotter heatbed temperatures.Read full review
Verified purchase: Yes | Condition: New