CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Paints
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Paints
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
I always use this product for gluing my 3D prints, it is very strong on plastics and has a long metal nozzle to get into the small gaps making it easy to use! Just ensure you are careful with the application because it will leave a visible mark if you get leakage or accidentally get it on the surface of a model.
Verified purchase: Yes | Condition: New
A little hesitant regarding claims I had seen and heard, but hadn't found that ideal applicator and glue source for the smaller items, doesn't cover every application and materials but covers a fair few, so gave it a go for the price. Brilliant, needle perfect for applying in correct position in those tricky areas, without waste or messy cleaning up to contend with. Couple of small issues;- (1) Ensure needle had been fully fitted once outer cap removed mine came out but no issues replacing and making sure all OK. (2) Clean/wipe needle after use. (3) Store upright or on it's base with needle at angle, don't store on side. Recommended addition to any glue stock
Verified purchase: Yes | Condition: New
As a keen modeller I use a number of plastic adhesives for kit construction. Revell contacta glue is easy to use and can accurately be applied by the thin metal applicator. The glue takes a couple of minutes to set but gives a strong bond. Use in a well ventilated area as it does have a strong chemical smell. All being said I think this is a good product but keep a thin piece of wire handy as the applicator occasionally clogs.
Verified purchase: Yes | Condition: New
The glue is excellent for getting into tight spots using the needle like nozzle and works very quickly on the specified plastics. Further I found that the glue does not solidify when not being used. One negative point concerning the container more specifically the yellow nut holding the needle assembly in place: this has a left hand thread (which I only found out after trying to loosed it) and when I tried to loosen the nut it burst. I cannot remember why I wished to loosen the needle assembly but please be aware of the left hand thread.
Verified purchase: Yes | Condition: New
Great product, needle tip is precise and accurate, used it on a level 5 model, careful with very small parts too much glue will melt the plastic, not a product issue more a user, will definitely buy again 😂
Verified purchase: Yes | Condition: New
