Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other Metalworking Supplies
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Metalworking Supplies
I wouldn’t bother with these. Mine came over and under size. Tested on the same rod. Some are crunchy and none of them could be called smooth. Liberally lubricated and still not smooth. Don’t waste your money. Buy better quality.
Verified purchase: Yes | Condition: New
My rostock printer came with brass bushes and it wasnt long and they were totally worn out and i could not print anything The new linear bearings ( i used 2 per rod) make a massive difference and have completely transformed my print quality A must do mod for anyone with brass bushes, do it now, you wont regret it
Verified purchase: Yes | Condition: New
Needed new bearings. Good value for the 12 pack. Bearings come in sealed packs of two, not loose.
Verified purchase: Yes | Condition: New
I'm using these in my hobby CNC with great accuracy. They fit recycled 8mm printer shafts without spinning. I also have a pair of 5/16 rods (7.8mm) on either side of my bigger cnc (4ft 1.2m) and there is a bit of lash so I just used extra bearings and it works well. Recommend.
Verified purchase: Yes | Condition: New
Fit well into 3D printed bearing blocks to upgrade Aldi 3D printer. 1 of the bearings was seized but the rest were fine. Good value, fit well. Will buy again when I need more.
Verified purchase: Yes | Condition: New