A good and simply set up device if you read the instructions carefully. A few issues . To maintain it's accuracy you really need around 500mm of clearance between the highest water level and the sensor/transmitter. This is quite a lot and much more than most tanks which try to limit wasted head space. Secondly it has a sensor send time of around every 20-30seconds, maybe more so. When you set it up, be patient and wait for enough time for the transmitter to send it's next signal and then the receiver/display will refresh the screen properly. To reset the levels, press SET and ALARM buttons for 5 secs. Instructions buried in the text...
Verified purchase: Yes | Condition: New
There is not much out there when it comes to water level monitors I spent about two hours looking online for such a monitor and could not find anything so there is a big hole if someone want's to make one of these monitors because as far as I can tale the way most of them work is buy a 5 bar system or more witch is ok. but I don't understand if it is Ultrasonic why can't it be programmed so you put in the size of your tank in my case it is a 5000 LT and then the monitor can workout how much water is in there that would have to be very easy for a monitor to work out but it must be hard because know one is doing it .
Verified purchase: Yes | Condition: New
Good
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Flow Meters