 |
I'm a big fan of Lee products. As much as I like this I have had trouble with the primers getting caught up when feeding into the bit holding the shell holder. very easy to operate and seats the primers well.
Verified purchase: Yes | Condition: New
A great idea ruined by cheap materials. Was fiddly to set up but got it to work well - for approx 300 rounds. Then the cheap plastic (working) components self destructed. No spares available and no use now. I thought it was a cheap primer - it turned out to be a very expensive desk ornament. The metal components left are in great condition - they should have made the load bearing parts in metal and not plastic.
Verified purchase: Yes | Condition: New
After setting up the unit, started re-priming. Worked around 5 times...then nothing. Noticed a primer had got stuck in the system and that the pressure of pushing the lever destroyed the cheap plastic plunger arm...the ebay shop I purchased from indicated that the fault was mine and that the shellplate had to be sticking up in the way of the mechanism? My bad or so I thought? A week later , new plate ordered from local shop as ebay seller had no spares...tried the same thing. Watching very carefully, that the shell plate was in the correct position.....same thing happened again. Primer jam, cheap plastic plunger damaged. Total waste of money....I will not try a third time it's too frustrating and too expensive. I'm guessing the plunge arm on the press is pushing too long? Construction looks cheap....plastic components very weak.... Never again.Read full review
Verified purchase: Yes | Condition: New
Primers did not flow easily at first. Had to polish the primer feed so that the primers can flow easily. Had no problems since then. Primers are seated correctly with minimal effort. The separate function of priming using this bench primer has contributed greatly to quality control as opposed to auto-priming with a progressive reloader. Good value.
Verified purchase: Yes | Condition: New
The only issue is the infeed of Small Rifle Magnum primers in that the plastic feed hole is slightly miss aligned. After a tinker you can get to work ok. Lots quicker than hand units.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other Hunting
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Hunting
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
