Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Quadcopters & Multicopters
After installing this kit on my V911, and adjusting down all the cyclic throws to accommodate the reduced range of movement, I noticed an extreme vibration was present. I traced it to the machining of the flybar pivot pin hole, it was about 1.5mm off centre. My only option was to counter offset the flybar weight with tape to make it flyable, but then, after only a minute in the air, the guide pins for the lower actuator linkages fell out. After much searching, they were located, and found to have been only glued in, and only to a depth of about 3mm.. no wonder they fell out, now no amount of repair can fix that, short of fully machining the holes to proper depth and making proper press fit pins, not likely for the time value. All in all this kit is not a very good choice and will actually downgrade your heli, so I do not recommend it.Read full review
Verified purchase: Yes | Condition: New
I found this product to be well made a very durable it looks great on the v911 helicopter does need some small adjustments on the servomechanisms buy a very well made product so much so that I got two of them one for each of my v911s and there not hard to fit only takes about 10-15 minutes
Verified purchase: Yes | Condition: New