About
All feedback (787)
- vinmay (513)- Feedback left by buyer.Past monthVerified purchaseGreat communication. A pleasure to do business with.
- cosmoretroshop (25733)- Feedback left by buyer.Past 6 monthsVerified purchaseSehr angenehmer Geschäftspartner. Cosmoretroshop sagt c u again !
- jiumy1005 (883)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended
- zappa986 (678)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- oz.office (73325)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat communication. A pleasure to do business with.
- skeletonfactory (1228)- Feedback left by buyer.Past 6 monthsVerified purchaseAll good. Thanks.
Reviews (2)
15 June 2018
Ender 3 Printer - setup tips
8 of 8 found this helpful Fabulous printer. Easy to assemble. Once calibrated it produces some of the best PLA prints I've seen and I have 3 other printers, most more expensive, to compare it against.
Would make a great first printer or as in my case an additional printer dedicated for printing of miniatures.
So would I recommend it, well YES. At this price point it's hard to go past it.
Just take your time with the assemble, DON'T tighten all the nuts to the very last thing. Be sure to square everything up then do your final tighten.
If the bed had the wobbles use the concentric nuts on the rollers to reduce the wobble. Remember to heat the bed then level (tramm) and be sure to set the nozzle height to the thickness of a sheet of paper. If you've completed these steps correctly you should be good to go. Best of luck.
10 September 2020
Jacquard Air Brush Colours
OK but a couple of the colours must have been sitting around for a long time as they'd dried and become hard.