beller0phon on eBay

About

Location: United StatesMember since: 26 February 2000

Feedback ratings

Last 12 months

Positive5- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (279)

depotlocker (234)- Feedback left by buyer.
More than a year ago
Verified purchase
Hope to deal with you again. Thank you.
miniduino (353706)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
anita9950 (1856)- Feedback left by buyer.
Past year
Verified purchase
Great communication. A pleasure to do business with.
trwil94 (256)- Feedback left by buyer.
Past year
Verified purchase
¸,ø¤º°`°º¤øøø•• E•X•C•E•L•L•E•N•T ¤¤ E•B•A•Y•E•R ••øøø¤º°`°º¤ø,¸
wang_yifei (49156)- Feedback left by buyer.
Past year
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
droneaccessory (3980)- Feedback left by buyer.
Past year
Verified purchase
Great communication. A pleasure to do business with.

See all feedback

Reviews (1)

NiteCore NDF25 25.4mm Flashlight Diffuser Lens Wand for MT2C MT21A P10 P12 P12GT

27 February 2017

It cracks around the rim (brittle). Clear plastic (not frosted). Tip can be blinding.

I got this (Nitecore NDF25 wand diffuser) for my TN12, as it says it fits 25.4mm bezels, and it was a perfect fit. Not tight, but not so loose it would easily fall off. Since it is all hard plastic there is no flexibility, so the fit has to be perfect. Another 25.4mm bezel light I tried was just barely too big, but it might as well have been a foot. After a few days, small cracks started forming all around the rim, many a cm or longer. I started hearing a cracking sound too when I put it on, which I've done just a couple of dozen times. It still fits the same, but I've wrapped it with tape just in case. Not sure how long it will last. Its "cousin", the Nitecore NFD25 lens diffuser (not a wand), uses a flexible rubber ring to fit around the bezel, stays on great, comes off easy, and looks like it will last forever. I wish they had done something similar with this. Since the plastic is more clear than frosted, it's not as diffuse as it could be. This also means the light concentrates at the tip and reflects from there, instead of emitting more from the entire length. If you go outside (due to your night vision) the tip can be blinding, like if you were pointing your flashlight at your face, and I find myself holding it as far to the edge of my peripheral vision as I can. Not very useful. UPDATE: I took eirikand666's advice and scuffed it all up with a file and emery board to make it more "frosted". Works a little better now.

See all reviews