About
All feedback (441)
- *****- Feedback left by buyer.More than a year agoVerified purchaseThank you for an easy,pleasant transaction.Excellent buyer.A+++++++
- liontop99 (20643)- Feedback left by buyer.Past monthVerified purchaseGreat communication. A pleasure to do business with.
- *****- Feedback left by buyer.Past monthVerified purchaseThank you for your purchase. Your feedback is appreciated and helps us improve.
- budgetpetproducts (254111)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- joylester75 (63485)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat buyer. Prompt payment and excellent communication. Highly recommend.
- em-9175 (8184)- Feedback left by buyer.More than a year agoVerified purchaseHope to deal with you again. Thank you.
Reviews (3)

22 December 2020
Great quality and price
good quality kit, No issues fitting anything to my 2004 4.8L patrol.All Japense bearings as described. All seals seem fine also. The only improvement would be to include swivel hub bearing grease cover plates x 4 as they are prone to minor damage when you tap these bearings out (I managed to straighten mine out ok though just need a thin punch to minimise damage). I had to make up a tool to knock the stub axle bearing out from a 12mm piece of solid rod (youtube video should help on that). The smaller outter wheel bearing was a tad tighter going onto the stub axle than the bearings I took out and I had to give both sides a light tap into place before I could get the bearing nut to go onto the spline (will be interesting to see on 1st regrease how easily it slides back off). Also needed to make sure I really pre-loaded the bearing with the torque wrench to over 160Nm as at first I had trouble getting the circlip onto the axle I'm guessing because that bearing was still needing some help on it's way home (make sure you have the Patrol bearing tool). Overall recommend this purchase. Massive cost saving from genuine. Don't forget to go for a short drive and then check bearing adjustment again. Mine needed a nip up so I didnt apply any silicon onto the locking hub assembly until after the readjustment.

18 July 2020
Great product
Good solid product looks like good quality. Im running some 50V led lights off a 24V system. Was easy to adjust. Terminals were strong. I'm only running about 90 watts but no heat at all. Good solid big heatsink on it. Have only run it for a few hours but i like it and am hoping it will last.

14 June 2017
Highly recommended group seal
Good price. These are quick and easy to install and at this price ill do it more often to maintain a good seal. Have been using for a month and can recommend.