clem-clone on eBay

About

Location: United StatesMember since: 17 August 2011

Feedback ratings

Last 12 months

Positive26- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (139)

l***r (596)- Feedback left by buyer.
Past 6 months
Verified purchase
A+ seller. Shipped fast, packaging was excellent, received as described. Great transaction.
thepartsdepartment (175693)- Feedback left by buyer.
More than a year ago
Verified purchase
Great communication. A pleasure to do business with.
mozok11 (10455)- Feedback left by buyer.
More than a year ago
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
high.quality.electronics (1162)- Feedback left by buyer.
More than a year ago
Verified purchase
Great Ebayer! Prompt payment!
eztechflip (2550)- Feedback left by buyer.
More than a year ago
Verified purchase
Very pleasant and courteous buyer, great to deal with, Thanks!
newtradetech (3500)- Feedback left by buyer.
Past month
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.

See all feedback

Reviews (2)

2005-2008 Porsche 911 997 Boxster Cayman 987 PSM Stability Control Switch Bank 9

23 June 2021

Replacement part works well

An annoying problem with this switch. It worked, then it didn't. I took it apart but couldn't find anything wrong, as it's a passive circuit board. I ordered the replacement part and it worked immediately. I took the old one apart again and discovered the problem. I took it apart and noticed these were all passive components, just switch contacts, resistors for the LEDs and the LEDs, all leading to the set of connector pins. I traced the switch circuits first and discovered no continuity through the 'feed-thrus' or 'vids' the small holes that routed the circuitry from one side of the board to the other. My solution was to scrape away some of the coatings at the feed-thrus and solder a small wire thru the hole. The hole should be plated-thru but this was obviously the weak point with these very small holes. I did this for both switches. The LED circuits were fine. I found the '+' and '-" points on the connector, connected that to my bench power supply and confirmed the LEDs worked. I cleaned it all up, re-assembled it and it works perfectly again. It will be my spare

Power Supply 300W iMac 27 2012 2013 5K 2014 2015 2017 2019 2020 A1419 A2115

20 July 2025

Thank you, this works great...

Thank you, this works great

See all reviews