About
All feedback (768)
- *****- Feedback left by buyer.More than a year agoVerified purchaseFantastic service. Good quality product. Highly recommended seller. Excellent communication. Friendly / helpful and informative. No problem at all. Very helpful seller. Went out of the way to arrange collection etc. Trustworthy. Honest seller.
- maltingsoffroadltd (58929)- Feedback left by buyer.Past monthVerified purchaseHope to deal with you again. Thank you.
- dkn-leisure (12458)- Feedback left by buyer.Past 6 monthsVerified purchaseThanks for choosing DKN ONLINE for your purchase we hope to see you again soon
- h102ilyas (1328)- Feedback left by buyer.More than a year agoVerified purchaseHope to deal with you again. Thank you.
- hellos88 (6695)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- u36home (4472)- Feedback left by buyer.Past yearVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (5)

28 July 2021
quick service but I think expensive
thought for what they are made from and size that they were a bit expensive.

10 April 2019
the 1 I got was no use at all, might be worth paying a bit more for a known brand..
the saw was nicely boxed and at first sight was a good looking tool, but when it was turned on it seemed to run a bit rough, and after a few minuets work on 1in mahogany board cutting out some new garden seat slats, the saw slowed down and would not cut anymore with lots of sparking from the brushes. The saw did not smell or feel hot, it seemed like the rotor failed.
Not good for a 1500w saw.

07 December 2024
made for BMW X5 but used on Range Rover L322, same bushes and NNO sub frame removal.
Nice tool made well
This is for the BMWX5 But it also works on the Range Rover L322 as the bushes are almost the same.
Easy to use and well worth the money. Only down side for me was the plate for pushing the bush back in has a centring tube that was over size for my bushes and got firmly stuck in the bush, I had to grind a couple of guides off the extraction barrel to remove the bush again this the push plate stuck into the bottom of the bush, and once it was out I had to destroy the new bush to get the push plate out, so an extra 89 quid cost.
So BEFORE you push your bushes in, check that your bush bore is larger than the push plate centring tube, if its not, grind it down till it is as its a right job getting it out again if you get the push plate stuck>