desertwind5555 on eBay

About

Location: United StatesMember since: 15 January 2003

Feedback ratings

Last 12 months

Positive6- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (366)

ourfoundtreasures (150)- Feedback left by buyer.
Past year
Verified purchase
Prompt payment received, good selling experience.
106shades (59110)- Feedback left by buyer.
Past year
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer.
huanyao49 (575)- Feedback left by buyer.
Past year
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
american_costumes (78831)- Feedback left by buyer.
Past year
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
retohos02 (835)- Feedback left by buyer.
Past year
Verified purchase
Hope to deal with you again. Thank you.
legends-distribution (230532)- Feedback left by buyer.
Past year
Verified purchase
:*'""*:•.Smooth fast transaction. Highly recommend this Buyer •:*'""*:•

See all feedback

Reviews (5)

Vehicle Speed Sensor Motorcraft DY-588

13 September 2021

Works great

I had to replace a leaking one and it was causing intermittent drop outs in my speedometer, So far it's working perfectly no more transmission fluid leaks and speedometer works perfectly.

Ceton InfiniTV 6 ETH Digital Network Tuner + Power Supply

20 May 2020

Good if you are computer savvy otherwise could be a headache

I'm using this with windows 7 Professional 64 bit. Setup was fairly easy But a little flaky at first. After searching the internet I found older firmware so I went back to one previous firmware and it works good now. also the first cable card from the cable co was bad had to exchange it then it worked. It takes a little long to tune about 5 to 15 seconds causing tuner not found error messages, Found a registry hack to increase the tuner timeout and the tuner not found messages are gone. Also installed EPG 123 and subscribed to schedules direct and now have a much more accurate guide then i ever had through Microsoft. So now I can record 4 OTA and 6 cable channels at once. Needs Gigabit network to use all 6 tuners at once. A little advice if you reboot the tuner you have to reboot all computers on the network or the tuners won't be scene. And it takes a while everything to scan and sync up. I'm happy but the product could be better but I'm computer savvy this might not be for you if your not computer savvy

Bench Clamp Drill Press Holder Adjust Workbench Repair Tool for Hand Drilling US

31 January 2023

Not the best quality, Binds.

Needs some kind of bearing to prevent binding. There is metal to metal contact between the column and the head. I use this to drill circuit boards using 0.8mm tungsten drill bits. I broke a few bits drilling just one board because of the binding I tried grease to no avail. The press starts to bind and you have to pull the handle harder then it frees up and the sudden movement brakes the bit. This gets worse as you continue to use it. This press needs some kind of bearing between the column and the head to prevent binding. also the point at which the downward pressure is applied is too far forward causing a slight forward rotation of the head causing even more binding. Maybe if you were using a larger drill and bits it might be ok but I doubt it.

See all reviews