Skip to main content

About

Location: United StatesMember since: 02 March 2017

All feedback (18)

  • yesautoparts2 (57548)- Feedback left by buyer.
    More than a year ago
    Verified purchase
    Good buyer, prompt payment, valued customer, highly recommended.
  • install_depot (175948)- Feedback left by buyer.
    More than a year ago
    Verified purchase
    Good buyer, prompt payment, valued customer, highly recommended.
  • *****- Feedback left by buyer.
    More than a year ago
    Verified purchase
    Thanks for the quick payment! Great Buyer!
  • powered_by_moyer (263036)- Feedback left by buyer.
    More than a year ago
    Verified purchase
    Hope to deal with you again. Thank you.
  • bie768- Feedback left by buyer.
    More than a year ago
    Verified purchase
    Super fast payment. Asset to EBays marketplace.��
  • zorotools (1206194)- Feedback left by buyer.
    More than a year ago
    Verified purchase
    It’s been a pleasure. For more, see www.ebaystores.com/Zoro-Tools
Reviews (4)
81873524 Oil Pressure Switch Sending Unit Fits FORD 2000 3000 4000 5000 7000
11 September 2019
What I Needed
This oil pressure sending unit is for a ford 3000 which is on a 12 volt system. I used on a Ford Super Dexta which has been converted to a 12 volt system. I have replaced the Ford Super Dexta original replacement twice. I think because it was originally a 6 volt system now a 12 volt system. They did not hold up! Hopefully this one will continue to do the job!
A/C Blower Motor Resistor For AVALANCHE SILVERADO SSR SUBURBAN TAHOE TRAILBLAZER
07 July 2017
Out of the box installation
The resistor comes with all wires however it has two bare wires which have to be tied in to the circuit. The product description states direct out of the box installation. The box could at least have instructions if the bare wires are going to have to be spliced into a terminal end.
1 of 1 found this helpful
Ignition Switch for many New Holland 5640, 6640, 6640O, 7740, 7740O, 7840, 7840
07 July 2017
Trouble Shooting Finale
This switch was an identical replacement to the OEM product. Original switch worked great until it was turned to the starting position. At that time it dropped voltage to the automatic fuel shut off therefore it would not start. It could be started by running a jumper from the battery to the auto fuel shut off until it started then release the jumper. New switch solved the problem.