About
All feedback (699)
- 4***8 (1269)- Feedback left by buyer.Past yearVerified purchase5 star seller hands down
- lombardosupplies9 (14697)- Feedback left by buyer.Past monthVerified purchaseHope to deal with you again. Thank you.
- the-drum-connection (1500)- Feedback left by buyer.More than a year agoVerified purchaseGreat buyer fast payment highly recommended! A+
- justapotamusdesigns1202 (1378)- Feedback left by buyer.More than a year agoVerified purchaseGreat ebayer fast payment!!!
- oemappleparts87 (5321)- Feedback left by buyer.More than a year agoVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- chrisatgmcs (126591)- Feedback left by buyer.More than a year agoVerified purchaseGreat communication. A pleasure to do business with.
Reviews (5)
22 July 2020
Super clean! Not just packed well... Packed appropriately
The motherboard was appropriately packed in ESD Lumiloy and that was well bubble wrapped inside of a box. That box was bubble wrapped in a larger box.
The motherboard looked new. All of the thermal compound was expertly cleaned from around the CPU and GPU dies.
Kinda pricey, but hard to complain
24 May 2017
407C
3 of 3 found this helpful It is what it is. Replaced compressor and swapped out R22 to 407C and oil from MO to POE. Subcooling and super heat were lower than expected (9 deg vs 15) without adjusting TXV. Used both weigh-in and subcooling to charge
26 January 2016
Power supply setting
1 of 1 found this helpful My power supply was set to 220v. Make sure you check it. It took me a week to figure out what was wrong. You should tune your PID anyway (look at RepRap site). I also suggest that you flip your heatbed (if you want to print Nylon)