garblyth-0 on eBay

About

Location: United StatesMember since: 02 November 2015

Feedback ratings

Last 12 months

Positive7- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (70)

maremoto_marine (1143)- Feedback left by buyer.
More than a year ago
Verified purchase
Great buyer, prompt payment, valued customer, highly recommended!
laskey.enterprises (1454)- Feedback left by buyer.
Past month
Verified purchase
A+ Buyer! Thank you for your purchase!
egogo-tool (22901)- Feedback left by buyer.
More than a year ago
Verified purchase
Hope to deal with you again. Thank you.
one-proud-daddy (8818)- Feedback left by buyer.
Past 6 months
Verified purchase
A+++ Ebayer ..Thanks for supportin us little guys! :)
2coats4u (5803)- Feedback left by buyer.
Past 6 months
Verified purchase
Hope to deal with you again. Thank you.
usaspeed (21630)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.

See all feedback

Reviews (2)

ACCEL 5000 SPARK PLUG WIRES SBC 350 383 400 406 FOR HEI & POINT 5041-K CLEARANCE

25 November 2020

Worked great on stock Corvette 350 with ignition shielding

I was wanting low resistance wires for my 71 Corvette 350 with stock points and coil. These wires had only 20% of the resistance of the stock Delco Professional wires. The universal set had plenty of length to reach the front plugs through the Corvette ignition shielding along the side of the block. The lack of installed distributor boots made it easy to feed the wires backwards through the shielding. The 8 mm wires fit through my ~50-yr-old rubber wire looms with no issues. The black wire colors look stock, and my idle quality is much better with the low resistance wires and low-energy ignition.

6" x 30' Black SAFETY GRIPTAPE Non Skid Grit FOR STAIRS & MORE Anti Slip Grip

01 December 2023

A lot of anti-slip tape for the money

I ordered this to apply to my 29-year-old boat trailer that had long lost its anti-slip appliques on its fenders and step surfaces. I needed a mixture of 6-in and 9-in tapes to match the original anti-slip areas, but I was able to cover the 9-in areas with a 6-in and half of a 6-in piece cut to the same length and split down the middle. It all went on great and I have quite a few feet left if I should need to replace any of them in the future. And the roll arrived very promptly after I placed the order.

See all reviews