About
All feedback (186)
- artspicescom (398)- Feedback left by buyer.More than a year agoVerified purchaseGreat communication. A pleasure to do business with.
- buonshopping (216180)- Feedback left by buyer.More than a year agoVerified purchaseHope to do business with you again. Thank you.
- metalwork2020 (422)- Feedback left by buyer.More than a year agoVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer! A++++++
- cntop201301 (367)- Feedback left by buyer.More than a year agoVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- hkdz-2018 (5026)- Feedback left by buyer.More than a year agoVerified purchaseGood Buyer. Patient and gentlemen. Fast payment .A
- *****- Feedback left by buyer.More than a year agoVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
Reviews (11)
18 July 2017
well built, but poor machineing
I had to take the vice cap to the milling machine and make room for the heads of the mounting bolts. The size adapter sleeves needed the swarf from the saw cut slits cleaned up. Once that was done, it removed the barrel just fine and the only problem was that it also removed about 3/4" square inch of skin when it finally popped loose and the cheater bar swung up to scrape the back of my right hand on the edge of the plywood top of the shop made table I bolted it to a leg of. That of coarse isn't your fault, that barrel was last installed in 1978.
Would I buy it again? Yes but hole location tolerances could be tightened up a bit. I fixed it up and won't have to do that again. Its a good, sturdy tool otherwise.
15 December 2020
its a time bomb, just waiting to start a fire.
My main dislike is the teeny teeny terminals for both power input and motor output, they are no where near big enough to handle the 10 amps pluis of current this device uses. I brought a 4 wire, 12 gauge wire to it, and there is not room to connect it without wire nutting some 16 gauge fot the last 4" into it. 16 gauge will run hot and burn up because those tiny screws have zero chance of surviving an attempt to tight them enough to actually get a gastight connection, so it is going to overheat the connection and burn it up. Probably 2 years down the calendar, or less.
18 August 2020
It Just Works.
It Just Works. Thank you.