greatbuyer2021 on eBay

About

Location: United StatesMember since: 17 January 2012

Feedback ratings

Last 12 months

Positive5- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (166)

carpartswholesale (3368590)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
thediscountspot-us (40794)- Feedback left by buyer.
Past 6 months
Verified purchase
Hope to deal with you again. Thank you.
arminamirrezaii (11552)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
louis1939 (911)- Feedback left by buyer.
Past year
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
superawesomegreatdeals (1040)- Feedback left by buyer.
Past year
Verified purchase
Great Buyer. Fast Payment.
shanxiduleishouxin-0- Feedback left by buyer.
More than a year ago
Verified purchase
Quick response and fast payment. Perfect! THANKS!!

See all feedback

Reviews (2)

Everbilt EFTET2T Thermal 2 Gal. Expansion Tank

05 May 2024

Good to have it finally replaced faster shipping helped.

Double Eye Jewelry Watch Repair Magnifier Loupe Glasses With LED Light 8 Lens

22 February 2018

Light weight and white LED's light up work nicely very recomended to use.

Plastic lens holder focal point is far to wide for X25 magnification close up work. X10 also splits ocular view point into separate images spread far apart, even with both lenses full inward position. Both lens holders need to be twisted inward to form a single image of fine pitched circuit pads even at X10. Any other magnification puts face very close to working surface. If you close one eye or even pinch the lenses together then a single image appears but only for close up work leaving little space for any tool movement, 3-4 inches. That again puts one face very close to any work being done and is a bit dangerous when soldering IC chips onto pads with face 8-10 inches from circuit board surface. Ideally the work to be done must be elevated placed on top of a box or other lifting surface to reduce stooping down head to bench level in order to reach the magnification surface with soldering iron or other tools. I do wear glasses for astigmatism correction, so split images may not be an issue for everyone.

1 of 1 found this helpful

See all reviews