grti.us.qd3jih3190 on eBay

About

Location: United StatesMember since: 22 September 2014

Feedback ratings

Last 12 months

Positive65- positive feedback in last 12 months

Neutral0- neutral feedback in last 12 months

Negative0- negative feedback in last 12 months

All feedback (341)

carpartsshippedfast (4195)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
micsca-984 (443)- Feedback left by buyer.
Past 6 months
Verified purchase
Great buyer smooth transaction. Thank You
xbdx75 (1246)- Feedback left by buyer.
Past 6 months
Verified purchase
Great communication. A pleasure to do business with.
istore-net (13830)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
governmentpropertysurplus (7627)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
bluebirdnestvintage (7908)- Feedback left by buyer.
Past 6 months
Verified purchase
Hope to deal with you again. Thank you.

See all feedback

Reviews (16)

JZBRAIN 8'' Center Commercial Faucet Wall Mount Kitchen Faucet with 14 Inch

30 April 2020

Good

I bought 2 different types of faucets. Both types had rubber washers in the areas where they needed secured to the sink. It was difficult to tighten properly without over tightening and alignment of the fitting towards the pipe. They should have been designed without the rubber washers in these areas and use only pipe dope or Teflon tape. The design would lead to possibly leaking in the future due to the initial overtightening or undertightening. Eventually I butted the fitting up against the rubber washer and held the fitting with pliers while tightening the brass nut up against the sink surface.

Estwing E-5 Sure Split 5 lb Splitting Wedges

19 January 2025

I have been using standard metal wedges ...

I have been using standard metal wedges on wood for years. They always seem to lack that last little bit of spread to split the wood. I can tell just by looking at this one that when that 20lb sledge hammer hits it, that extra width from the wings on it will make a very big difference! I've been using a slate bar to finish prying the wood apart, which is a very big help. I won't be using that bar as much now. Just finished a 4ft diameter white oak and wish I would have found this style before.

(35) Hex Head 1/2 x 4 Lag Bolts Galvanized Wood Screws

09 February 2019

great for my project

excellent as described in the ad

See all reviews