About
All feedback (354)
- mg-efforts (6910)- Feedback left by buyer.Past monthVerified purchase✔❤❤❤ Hope to deal with you again. Thank you. ❤❤❤✔
- jon957 (313)- Feedback left by buyer.Past monthVerified purchaseGreat communication. A pleasure to do business with.
- cosmeticos01 (4641)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- truffulas_closet (362)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat ebayer! Would absolutely recommend!
- xraytw (2705)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat communication. A pleasure to do business with.
- nexster (4078)- Feedback left by buyer.Past 6 monthsVerified purchaseRide Eternal, Shiny and Chrome
Reviews (6)

12 November 2024
Flex mirror looks and fits like the OEM ...
Flex mirror looks and fits like the OEM mirror. So far, it works the same, but have to wait for dark to test the puddle light and a cold day to see if the heat works! Had trouble with a rusted bolt that broke and one of the pins was stuck in the socket. Took socket apart and used a razor blade to expand the socket and finally got the pin out! Not a fault of the mirror, just a rust belt car! Door panel was easy to remove with just 2 bolts (door pull and latch) and several screws around panel.

20 July 2021
Buy Trim Moldings for both sides since the other side is going to fail just like the messed up side!
Great product! Quick Ship! As described! Will buy again, but hope not too!!! LOL
This was the best price I could find for the pair and was often cheaper than buying just one side. I figured I might as well get the other side for only an addition $20, based on the single pricing. After I installed the new part; I checked out the other side. I gently pulled and pushed it to see how it was holding on and it let loose in a couple places! So it needs to be replaced to. I didn't have time so I'll get to it later...
But... These parts look and feel just like OEM, super easy to install.
My old ones were glued on by the people who installed a new windshield, so they had that heavy adhesive that was really hard to remove!
But after than, just push the new one on until you hear the clips click.
FYI, to remove the old ones that aren't glued on, pull/pry the top out, away from the pilar and slide the whole molding up to the top. There is a peg/pin molded into the plastic trim that seats into a hole in the pilar. if you pull/pry the trim up, it should release from the hole and stay above the pilar as you slide it out. This will release the clips from the molding. To remove the clips from the pilar, just turn them 90 degrees and take them out.

30 September 2019
NOT correct part for 2007 and up Polaris Outlaw 90 and Sportsman 90!!!
This is NOT the correct part for 2007 and up Polaris Outlaw 90 and Sportsman 90!!!
As other reviewers have stated, the part gets extremely HOT!!!
I hooked it up and went to get my volt meter to test if it was working, when I got back, my ATV wouldn't even crank. I checked the voltage on the battery and it was down to like 6 volts!
I was really confused. I touched the regulator and I almost burned myself!!! I had to quickly disconnect the connector so as to HOPEFULLY not cause any damage. After I reinstalled my bad old OEM regulator, I still had a hard time picking up this hot regulator!
IDK, maybe it works on some other ATVs, but not mine!!!