Skip to main content

joc45

About

Location: AustraliaMember since: 18 December 2003

All Feedback (136)

sohotday-6 (1808)- Feedback left by buyer.
Past 6 months
Verified purchase
Hope to deal with you again. Thank you.
mezon_au (60758)- Feedback left by buyer.
Past month
Verified purchase
Thank you for shopping with MEZON
jjskyeshop (206496)- Feedback left by buyer.
Past month
Verified purchase
▀▄▀▄▀▄▀▄█▓▒░ Thank you from JJSKY team! A+ Buyer *¨¨*: ░▒▓█▀▄▀▄▀▄▀▄▀▄
joyful.living (12433)- Feedback left by buyer.
Past year
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
perfectyou05 (121403)- Feedback left by buyer.
Past year
Verified purchase
Hope to deal with you again. Thank you.
aussie_beauties (28771)- Feedback left by buyer.
More than a year ago
Verified purchase
Hope to deal with you again. Thank you.
Reviews (3)
35M-4.4GHz PLL RF Frequency Signal Source Generator ADF4351 Development Board ZZ
05 July 2018
Great synthesiser
It wasn't that long ago that a microwave synthesised signal generator cost thousands. Ok, there's a bit more to add to this one, but what the heck, it's a great frequency source that works to over 4GHz. The May 2018 edition of Silicon Chip (Australia) magazine has an article on this module and software to drive it.
RF bridge 0.5-3000 MHz, VNA Return Loss VSWR SWR reflection bridge antenna
02 July 2018
A great little product at a great price.
Arrived promptly. Well-made. Needs a 50ohm termination on one port of the bridge for measuring return loss, but these are cheap on Ebay. Haven't tested yet, but have read several favourable tests on Youtube, where the directivity is quite good to over 1GHz. (expect quite reasonable accuracy where the return loss measured in dB is half that of the directivity).
Car Paintless Dent Repair Dint Hail Damage Remover Puller Lifter 28 Tab Tool Kit
07 February 2019
It Works!!
Had a few small uncomplicated dents in the wagon (single-point dents rather than creases). Generally, it required more than one application to pull the dents out, but it worked fine and the wagon looks great again. Only thing missing was a hot glue gun, which I had to buy.