About
All Feedback (420)
r***j (87)- Feedback left by buyer.
Past year
Verified purchase
Excellent service, thanks. Just what I wanted, perfect condition, very well packaged, and arrived a day early.
n***1 (645)- Feedback left by buyer.
Past 6 months
Verified purchase
Very unique and interesting item. Great communications. Extremely fast delivery. Thank you!
longlonglong002 (724)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
modeltoycars (27647)- Feedback left by buyer.
Past year
Verified purchase
Great communication. A pleasure to do business with.
2***l (142433)- Feedback left by buyer.
Past 6 months
Verified purchase
Very nice eBayer with fast transaction and nice items.
k***u (1343)- Feedback left by buyer.
Past 6 months
Verified purchase
Got it
Reviews (4)
02 February 2017
Outstanding Tool
1 of 1 found this helpful I first purchased the cheap Chinese T962 ovens for building LED board prototypes. I was disappointed in the uniformity of heat, the top-down heat source (putting too much heat into the LEDs), and the small working area (effectively 3" x 4" where the heat is consistent.)
I decided to pick up the ControLeo2 kit and the recommended B&D oven and give it a try. Seemed strange to put $189 for parts into a $45 toaster oven, but what the heck, it's a box with heating elements, the rest gets binned in the build. The end result is better than I expected. The kit is complete, the instructions super easy to follow. 6 hours later I had a re-flow oven up and running. The heat distribution is excellent, and the process could not be easier.
Building the oven is a bit fussy, mainly with installing the insulation - but it is not massively difficult. Taping the door open is a big help.
I purchased two additional insulation components. I added one pc of Boom Mat to the rear wall of the oven, and wrapped the top and sides of the oven box with high temp fiber insulation to keep the exterior cooler and hold more heat in the box. I also made a new bracket to mount the controller more rigidly, but overall found no fault with the kit - I'm just finicky about the fab parts.
Started immediately after assembly, only required one learning pass, and flowed my first board at the end of the day. I also connected it to my PC and updated the firmware as instructed - another trouble free process.
This is a great setup for creating LED boards up to 5" x 10" using current SMT devices and related components. I could not be happier.
17 August 2016
It is a costume, not made like street wear
If you keep in mind that this is a costume, for party use or such occasion, it is fine. The material is lightweight and the quality of construction is not up to even bargain brand street clothing. The elastic in the back is also a little strange for those unused to that type of fit. But, for a night of fun in costume, this is a good buy.
01 June 2016
For 365nm Only
3 of 3 found this helpful The meter states on its packaging and in marketing materials that it works up to 400nm+. Older versions of this meter did work to some degree to 405nm. However, In the new calibration/sensitivity curve for the sensor now used in this does not see anything above 380nm. Sensitivity at 400 and 405nm is so low that the meter is unusable. If you are measuring sources centered at 365nm, this meter is a great buy. For anything else, it will not work.