About
All feedback (1,608)
- rightprice2you (68000)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- *****- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- bydatempler (3907)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- screwsnbits288 (1829)- Feedback left by buyer.Past monthVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- *****- Feedback left by buyer.Past monthVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- hyfive (293381)- Feedback left by buyer.Past monthVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
Reviews (11)
23 July 2020
Easy to replace the oven element.
You don't need to take the back off the cooker to replace the element. Electrically isolate the cooker, remove the four screws on the fan shroud and then the two screws that hold the element in place and gently remove the element giving access so as to remove the electrical spade connectors from the element. Connect the spades to the replacement element. Secure the element with the two screws and replace the shroud and screws. If you have a bad back it hurts leaning over and streatching over the door to get at everything. Reset the clock when power restored or it won't power up the oven.
25 April 2017
Anet v1.0 replacement board
Bought as a replacement for the faulty board on my Anet A8 printer. Superb value.
It is already pre-programmed with the software so worked straight out of the box.
It has the better quality teminals for the power supply and heated bed connections. Use crimp tags on the wires for these to assist in preventing overheating of the connections.
The Z offset in the EEPROM is set too high and needs changing so that the first layer prints at the correct hight. Use Pronterface on CURA to set and save the new value using the appropriate Gcode M codes
23 February 2017
Screw terminals 2.54mm or 0.1 inch spacing
My only negative comment would be they are difficult to line up, so they look neat ,when set out in a line. The terminals move a little in the housing.