About
All feedback (171)
- d-sotre (71845)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- webuybooks (2410027)- Feedback left by buyer.Past monthVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- better_world_books_uk (494967)- Feedback left by buyer.Past monthVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- tanaka_h_japan (793)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- claoner-shopuk (30316)- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- ledbriteuk (31039)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you very much for the order - please message us for 5% off your next order
Reviews (10)

14 February 2018
Good source of obsolete components
Purchased these devices to repair an old short wave radio. I could have looked for "equivalent" devices but wanted to try and keep the radio as close to original as possible. Not the same gain group (C as opposed to B) but this should not make a significant difference.

15 February 2017
A little icing on the cake.
I've seen a few Boxsters with a badge or logo stuck on the Perspex windbreak between the seats so I thought I would give this a try. I picked this particular decal as I liked the Porsche logo and the badge. It wasn't too big and the printing was fine enough to be suitably "see through" when reversing, yet noticeable enough when viewed from the rea of the car.
I did have a small problem when I started the application process as my decal seemed to be quite attached to the backing paper, rather than the transfer side. A vigorous rub with a credit card from the backing paper side seemed to fix this and subsequent application onto the well cleaned windbreak, following some masking tape guide lines and it applied quite smoothly. It does seem to be quite securely attached now, and looks great. Very happy with this purchase.

28 July 2021
Handy for securing Windows 10, essential for Windows 11?
These modules are becoming harder to find as time goes by. MS really stirred things up my making a TPM necessary for Windows 11. Hence prices are going up into silly territory.
Dead easy to install (just plug it onto the motherboard header) and enable it in the BIOS. Windows 10 picks it up automatically with no fuss and will use a Rev 2 TPM for automatic full disk encryption with Bitlocker.
I had to upgrade the firmware to the latest version from Infineon, which is a very manual process using a command line.
NOTE: Not all Asus motherboards will accept a Rev 2 TPM, even if they have the 20 pin header. Older boards only accept the Rev 1.2 TPM.