About
All Feedback (79)
- rainbowsunflowerinc (77233)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- fancystore2021 (108604)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- alsyrian (14614)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- eccppautoparts (453878)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- yupvparts (7653)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- parkobdstore (1393)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (3)
26 January 2021
Right fit and good value
It was delivered on time and it fit right. We'll have to see how long it will last as my older set had lost one of the 2 springs.
16 January 2019
Specific Battery Mount Not usable with other similar batteries
I was disappointed about its specific and displaced position of its Battery Mount Lock. So I cannot interchange its battery with my 2 other similar Power Drills that work just fine. I bought this drill just because I needed a Charger for the other 2. So at least, I can use its charger for my 2 other drill batteries but when its specific battery fails, I'll be stuck with 2 very similar batteries that I just cannot mount and have to buy a new battery just for it..
01 July 2020
Does a good job! Needs few Installation suggestions and better Magnet spacing
1 of 1 found this helpful So far so good, it does its intended job.. However, the spacing of the magnets could be improved to avoid the gaps on the Top and Bottom of the door. These small gaps allowed few flies to come into the room. Although it's easy to install, a little instruction sheet could help 1. to figure out which is the top and bottom ends. and 2. How much of a loose gap to leave free from the frame at the top to allow for a smooth opening of the flaps. I had first attached all of the widths of the 2 flaps but opening was tight which could also tear up the fabric. Then I left 2 inches from the middle line, on each side free, unattached and passing through became smoother.