About
All feedback (1,221)
- *****- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- sri-racing (15348)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- jdealstore (40498)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- sydco-usa (3542)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- copperstate3ddesign (475)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- retrogamerdepot (3552)- Feedback left by buyer.Past monthVerified purchaseHope to deal with you again. Thank you.
Reviews (7)
14 November 2019
Would probably buy it agin
Mag light 5 D Cell, Super bright focus tight spot light for long range but has donut shaped light when in flood light mode.
13 April 2016
Heavy duty test jump wire 36" 16 Gage.
It is hard to find jump wires in 16 gage so when i found these i bought them.
One of the Black jump wire alligator clips was incorrectly assembled and has no spring action to close. Other than that they are well built.
They have larger Wire, Bigger Alligator clips and Longer length than most.
I would not hesitate to buy another set as it is unlikely it would also have a problem.
27 January 2016
Kg's Boot Guard great stuff !
Great Stuff, Not only is it tough and long lasting but you can repair minor / major damage to your boots. After seeing how well it worked on my good work boot toes, I put it about three inches high all the way around on a old pair of my old heavily worn boots. Put it right over the nylon panels the welt everything except the laces toe to heel. Now i have waterproof winter work boots! When it was fresh and clean i did get a few interesting comments and questions. Evidently it looked like i had dipped my boots in tar. Once it is fully cured it dosen't appear to rub off or make black marks on anything . This took two cans for two coats.
The dauber that is included is hard to work with and messy. Instead use a popsicle stick for stirring and a small disposable brush for application. I used acid brushes they work great and are cheep. Use tape to keep your borders sharp. If you want to reuse the brush put it in a freezer to help keep it from drying out.