Skip to main content

pagtog

About

Location: United StatesMember since: 04 August 2002

All Feedback (970)

imssupply (11538)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
gura-1563 (658)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
lapidarytools (1943)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
actools_123 (4306)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
bigfuzball (1639)- Feedback left by buyer.
Past year
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
004-superyan (1123)- Feedback left by buyer.
Past 6 months
Verified purchase
Good Buyer. Patient and gentlemen. Fast payment .A
Reviews (25)
Dirty Dingo Adjustable Engine Swap Mounts LS1 Swap 78-96 Various GM Cars RAW
07 July 2016
77 a-body swap
lq4 long crank install into a 77 el camino with 2004 transmission went flawlessly. I left the transmission in its original position, set the motor straight down into the engine bay and slid the motor up to the trans and bolted it all down. be sure to check the alignment before you bolt the motor mounts down. I bolted all four block bolts down but would recommend only using three of the mounting bolts since one is a little hard to get to. the mounts set my engine down low in the engine bay giving enough clearance for the tall vortec intake on the top side, very pleased overall with these motor mounts and would recommend them if doing a swap. the price is a little more than some but the time and labor you save is well worth the difference.
Aftermarket 77817A Hub w/ Shaft for Reaction Carrier (Non Lip Brg Type) 4L60E
26 December 2018
good replacement part
looked the same to the oem that it replaced, perfect fit.
IMPCO LPG PROPANE CARBURETOR MIXER CA50 CA55 CA55-508
15 September 2021
honda atv
installed on a trx450fe atv, workes good so far, idle speed and mixture very sensatie as it is a bit large for this application just make small adjustments.also load adjustment was rich and had to lean considerably. not field tested yet but expect no serious issues mixer quality is excellent.