About
All Feedback (342)
aldaxmoulds (11103)- Feedback left by buyer.
Past year
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
digidirect2013 (56738)- Feedback left by buyer.
Past year
Verified purchase
Prompt payment, valued customer. Thank you! A++++
mobiusmme89v (2839)- Feedback left by buyer.
Past 6 months
Verified purchase
Great communication. A pleasure to do business with.
loopmobileau (5340)- Feedback left by buyer.
Past year
Verified purchase
Great communication. A pleasure to do business with.
alicesprings0870 (11792)- Feedback left by buyer.
Past year
Verified purchase
A+! Great communication, a pleasure to do business with! As a thank you for your support and business, here's a private 30% off coupon to use at checkout on your next purchase: 30THANKYOUS
carby_doctor (42199)- Feedback left by buyer.
Past year
Verified purchase
Great communication. A pleasure to do business with.
Reviews (9)
11 February 2021
Great Unit, hard to beat!
2 of 2 found this helpful I upgraded from the old 820 so not hard to be impressed by by the much newer 1030plus. Screen is double in size, great touch sensitivity, fast response moving maps around, great battery life compared with my old unit, found it easy to use and set up and the speaker is much louder.
09 May 2020
Bit pricey but very good quality.
Extremely sharp and good quality. For the price you wouldn't expect anything less though.
15 September 2020
Pretty decent tool for the price. It worked for my purpose and only 1/3 the price of more expensive tools.
1 of 1 found this helpful I bought so I could remove some small 6805 bearings in my TREK road bike with BB90 bottom bracket. One bearing has enough lip so you can tap out from the opposite side but the other bearing inner race is virtually flush with the inside of the housing so nothing to get a purchase on to tap it out.
This did the job perfectly. Like I said, on one side there is almost no clearance between the inside of the frame where the bearing is and the inside lip of the bearing so had to be very careful lining up the jaws before tightening them, and took a few thumps with the slide to dislodge both bearings but this tool did exactly what I wanted it to do, and did it without any detriment to the tool.
I read some previous reviews stating the lip on the jaws wasn't strong enough and gave way but I would question what they were trying to do with it, as I have a lot of tools and I believe this tool is made pretty robustly considering the price. I would think the sliding weight is not heavy enough to induce enough force to damage the lips of the jaws, but only my educated opinion and could be wrong. I also get that my intended purpose for this tool is not very demanding compared with what others might use it for but judging by the way it is made I think it should successfully remove most bearings without too much wear and tear. For my purpose there was zero wear and tear, although like I stated earlier, it's important to make sure things are lined up and sufficiently tightened before using it.
PS: OHS warning. Make sure the fleshy bit of all your fingers are out of the way before you start using the slider! I have a nasty bruise where I pinched the skin on my first heavy whack! Fortunately I think I'll live... :0)