About
All feedback (1,403)
- allaccesstrading (143018)- Feedback left by buyer.Past monthVerified purchasethank you for great transaction A+++
- gmmarkets (1678)- Feedback left by buyer.Past monthVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- sepw (27430)- Feedback left by buyer.Past monthVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- sheve9859 (971)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- joycejingling (212)- Feedback left by buyer.Past 6 monthsVerified purchaseAll went very Smoothly, Thank You, Enjoy!
- neverendingdeals29 (476)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
Reviews (4)

21 December 2017
Good dispenser
Has only one flaw, easy to fix. Have bought 8. All needed the same fix.
The holes are not quite right. Cover doesn't stay on well. Tends to not latch in place.
i drill out holes a bit larger with a uni-bit. Then bend the plastic tabs outward a bit - not too much or will break.
It's a shame they can't fix this at the factory.

25 March 2020
Great, needs minor mods.
1 of 1 found this helpful Works great! Save the arms, shoulders & wrists!
I have about 300 cans. Dreaded them shaking by hand, So never did.
(Note - I am using slow speed on a variable speed saw)
One star taken off because-
The clamp is awkward to release when tightened enough to keep cans from coming loose That makes my finger tips sore. Needs a longer release lever.
The rubber strap has to be positioned in a critical position with strap angled up & can held down while tightening, otherwise the cans loosen very easily. Maybe more curve on the clamp? Maybe make ti a 4 can unit, 90 degree separation (not 120), might make a tighter fit?
The rubber strap cog(s) seem to be wearing prematurely in the spot where almost all cans cinch tight. May have to replace sooner than anticipated.
Minor mods would make it perfect!

12 February 2020
Good , but.....
Has a lot of wind noise...I expected some, but not that much.
Instruction manual for the Podiums and the base adapters is comic book drawings....just about useless. Unless you read euro-hieroglyphics! An English sentence is worth a couple dozen hieroglyphics... just sayin. Even a good pic would have been so much better.