About
All Feedback (1,005)
wellpowertool (451)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
wellpowertool (451)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
marlin-plastics (10205)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
byronix (394391)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
bdlamotorbikesltd (52645)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
kct_leisure (67445)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
Reviews (12)
05 September 2018
Used to clean the awkward 435d Bmw 19” alloys
1 of 1 found this helpful Along with car pro iron x, this brush worked excellent to clean the wheels prior to ceramic coating them, recommend highly 👌
31 January 2020
Absolute junk, don’t waste your money
1 of 1 found this helpful Don’t waste your money, fell to pieces when I went to fit it, bulb clips in the wrong way so then the wiring harness fouls the washer tank located behind In the inner wing, white trim around edges that looks awful, avoid
08 August 2018
The only ‘red boost pipe’ to buy for your 335d
Followed fitting instructions, perfect fit, no comparison in stiffness of this pipe from the oem stock item. This should be the only choice of replacement pipe you buy for your Bmw 335d!
As can be seen from the pictures, this pipe has two very thick, traditional style, o ring sealing rings that attatch to the turbo outlet, very tight fit, make sure you grease up with red rubber grease the o rings so not to kink or tear them when fitting. Also I used some wd40 to slip the lower connector onto the silicone pipe when raising the intercooler back into place.
I found it easier to completely remove the intercooler from the car and fit the green o ring to the new forge lower coupler then grease it up and press it into place, this way you can make sure the coupler is fitted squarely and the o ring doesn’t become damaged.
A couple of things to note that aren’t stated in the instruction is that both the front side spats on the e92 platform cars need to be removed aswel as the undertray to gain access to the t27 torx screws that hold the intercooler in place. Also on the intercooler itself there is a small black tab that locates the stock pipe, this is not accommodated for on the new coupler, therefore it will not click all the way into place without removing this tab, I simply cut it off with some side cutters and filed it down smooth before fitting the new lower coupler into place.
Other than this, follow the instructions step by step and you can go wrong.