About
All Feedback (73)
thewurzel-0 (14832)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
jkeshopiot (26)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
autostars_inc (203422)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
summersunny1688 (111552)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
guitarmadnessguitarmadness (42406)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
axegrinderz (31547)- Feedback left by buyer.
More than a year ago
Verified purchase
‹(•¿•)› THANK YOU! FAST PAY! GREAT COMMUNICATION! SUPER BUYER! ‹(•¿•)›
Reviews (10)
19 March 2018
Big sound small price!
Was looking at the SD invaders when I found these. Took the chance after reading the reviews on these. At literally a fraction of the price, these are almost identical. Very hot pick ups. Nice high end that screams, tight low end that stays clear during chugs. Wire diagram was very clear. Comes with finish wires soldered together. ready to be taped off or used for coil splits. Neck wires are reversed from bridge, for coil tap to give you hum cancelling. Neck when split will be south side (closest to the fretboard) and bridge will be north when split (inner coil furthest from bridge).
19 March 2018
Very smooth.
1 of 1 found this helpful Smooth sweep from 0-10. Light enough to roll on or off with your pinky. Pull shaft has a solid feel and a nice click when engaging in and out. You can feel the difference in quality with these.
25 March 2020
These do not fit 1" bars.
The description of these is not accurate/misleading. These specify are made to fit 1" bars. Using there adapters provided the bar end insert will fit 7/8" or 1" if you change out one of the adapters. These will ONLY clamp onto 7/8" bars. Or there bar end insert. These will not clamp directly onto 1" bars. Besides that these are as expected. Quality is great was really hoping to run them. Ball socket on mirror end is made of plastic to allow tightening.